Practices Guide

LC Integration Best Practices Specification
48
Q) Poll jobstatus for Completed: GET the InstanceID of from M). See section 2.3 for a
definition of GET.
R) Poll jobstatus for Completed: GET the InstanceID of from O). See section 2.3 for a
definition of GET.
S) The Lifecycle Controller remote service must be in a “ready” state before executing any
other WSMAN commands. The GetRSStatus() method or the GetRemoteServicesAPIStatus()
method may be used depending on the version of the LC Management registered profile.
4.16 iSCSI boot using NDC/Broadcom (12G only)
This workflow sets several NIC attributes, including setup of iSCSI boot, by first setting the
required attributes for the operation, and then changing the boot order for the NIC. Additional
detail is provided as setting up iSCSI boot is complex. Approximate time for completion on a
12G system is 15-30 minutes depending on the system configuration.
NOTE: Additional details of the coding steps shown below, generational differences, and other
iSCSI information can be found in Appendix: iSCSI Boot information.
Applies to: LC2+
Prerequisites for script:
 Network Daughter Card (NDC) / Broadcom NIC
 This script will only work using an NIC FQDD of NIC.Integrated.1-1 or
NIC.Integrated.1-1-1
 Only works with first port-partition of 12G NDC (script limitation)
 System must be powered off
 Edit script to set desired parameters
Script: iscsiboot-12gNDC.win
A) The Lifecycle Controller remote service must be in a “ready” state before executing any
other WSMAN commands.
GetRemoteServicesAPIStatus():
B) GetBIOSEnumerations: ENUMERATE the DCIM_BIOSEnumeration class to collect
information about the system. See section 2.2 for a definition of ENUMERATE .
C) GetNICViews: ENUMERATE the DCIM_NICVIEW class to collect information about the NIC
FQDDs. See section 2.2 for a definition of ENUMERATE .
D) GetBootSourceSettings: ENUMERATE the DCIM_BootSourceSetting class to collect
information about the NIC FQDDs. See section 2.2 for a definition of ENUMERATE .
 Check whether the FQDD and IPL fields are in the boot order
 SetNICAttributes(): Set the attribute LegacyBootProto to the value “iSCSI” and the
other desired NIC attributes and values
 CreateNICConfigJob(): Pass RebootJobType=1