Practices Guide

LC Integration Best Practices Specification

116

Use the following procedure below to confirm the existence of the Base Server and Physical

Asset profile support in LC2.0+.

Applies to: LC2+

Prerequisites for script: none

Script: GetBaseServerAndPhysicalAssetProfile.win

A) The Lifecycle Controller remote service must be in a “ready” state before executing any

other WSMAN commands.

GetRemoteServicesAPIStatus():

B) GetLCRegisteredProfiles(): ENUMERATE the DCIM_LCRegisteredProfile class to view all

registered profiles. See section 2.2 for a definition of ENUMERATE .

C) Search for “RegisteredName= Base Server and Physical Asset” and note its instanceID to use

in step D)

D) GetLCRegisteredProfile(): GET the DCIM_LCRegisteredProfile instance using the

InstanceID from C). See Section 2.3 for a definition of GET.

Results for the InstanceID of DCIM:BaseServerandPhysicalAsset:1.0.0 shown below. If no

instance is returned, the profile is not supported.

DCIM_LCRegisteredProfile

AdvertiseTypeDescriptions = WS-Identify

AdvertiseTypeDescriptions = Interop Namespace

AdvertiseTypes = 1

InstanceID = DCIM:BaseServerandPhysicalAsset:1.0.0

OtherRegisteredOrganization = DCIM

ProfileRequireLicense

ProfileRequireLicenseStatus

RegisteredName = Base Server and Physical Asset

RegisteredOrganization = 1

RegisteredVersion = 1.0.0

24.2 Discovery of Base Server and Physical Asset profile support

[LC1.5.1]

There is not an LC registered Base Server and Physical Asset Profile prior to LC2.0. There are

however, separate Base Server and Physical Asset profiles.

Use the following procedure below to confirm the existence of the Base Server profile and

Physical Asset profile support prior to LC2.0.

Applies to: LC1.5.0, LC1.5.1

Prerequisites for script: none