Practices Guide

LC Integration Best Practices Specification
112
Results for the InstanceID of DCIM:Memory:1.0.0 shown below. If no instance is returned, the
profile is not supported.
NOTE: 12G example output shown below
DCIM_LCRegisteredProfile
AdvertiseTypeDescriptions = WS-Identify
AdvertiseTypeDescriptions = Interop Namespace
AdvertiseTypes = 1
AdvertiseTypes = 1
InstanceID = DCIM:Memory:1.0.0
OtherRegisteredOrganization = DCIM
ProfileRequireLicense = Remote Inventory
ProfileRequireLicenseStatus = LICENSED
RegisteredName = Memory
RegisteredOrganization = 1
RegisteredVersion = 1.1.0
21.2 Inventory of memory in system
Use the following procedure below to list the inventory of all memory DIMMs in the system.
Applies to: LC1.5.0+
Prerequisites for script: none
Script: GetMemoryViews.win
A) The Lifecycle Controller remote service must be in a “ready” state before executing any
other WSMAN commands. The GetRSStatus() method or the GetRemoteServicesAPIStatus()
method may be used depending on the version of the LC Management registered profile.
B) GetMemoryViews(): ENUMERATE the DCIM_MemoryView class to view all instances. See
section 2.2 for a definition of ENUMERATE .
The instance information of all available memory DIMMs will be returned.
21.3 Get the first memory’s information
Use the following procedure to get a single memory instance. The URI for getting particular
instance information is deterministic (i.e the InstanceID will be unique for each instance).
Applies to: LC1.5.0+
Prerequisites for script: none
 Set desired instanceID by editing script
Script: GetMemoryView.win