Users Guide
Table Of Contents
- Dell Migrate User's Guide
- Contents
- Introduction
- Data Migration
- Migrate and erase data from old PC
- Check the network settings
- Change the system locale
- Device discovery and pre-checks
- Unsupported Windows version
- Applications to close before migrating
- Start Migrate
- Launch Data Assistant on your old PC
- Launch Migrate through SupportAssist on your new Dell PC
- Code verification
- Migrate multiple accounts
- Searching for files and settings
- Troubleshooting network disconnect issues during migration
- Create Data Assistant shortcut
- Select files to migrate
- Mapping the drives
- Migration progress
- Migration summary
- Migration completion
- Retry or finish the migration process after it was canceled
- Troubleshooting migration failure
- Troubleshooting when migration is completed with warnings
- Issues while launching Data Assistant on old PC
- Data Erase
- Perform erase without migration
- Prechecks for erase
- Disabling BitLocker
- Troubleshooting hard disk failure issues
- Troubleshooting when external storage is found
- Set reminder
- Levels of erase
- Reset SupportAssist OS Recovery
- Windows reset Windows 10
- Prerequisites for resetting Windows 8.1
- Troubleshooting Windows reset
- Manual Reboot
Figure 30. Trusting the network on your new PC
Change the system locale
Change your system locale if your locale setting is not set correctly for the supported regions. Currently, Migrate service is only
available in the United States.
About this task
When Migrate is launched on the old PC, it runs a series of prechecks to validate that the PC has the required prerequisites for
Migrate. One of the pre-checks is the locale settings.
If the PCs are not on the supported locale, Migrate prompts you to change to a supported locale and try again.
Figure 31. Local setting not supported in Data Assistant
Steps
1. In the search box next to the start icon on the taskbar, enter control. Click Control Panel from the list of results.
22
Data Migration