User's Manual

Back to Contents Page

Setting Up the Monitor
Dell™E1909W Flat Panel Monitor User's Guide
Attaching the Stand
Connecting the Monitor
Organizing Your Cables
Attaching the Soundbar (optional)
Removing the Stand
Attaching the Stand

To attach the monitor stand:
1. Place the stand on a flat surface
2. Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.
3. Lower the monitor so that the monitor mounting area snaps on to or locks on to the stand.
Connecting Your Monitor
To connect your monitor to the computer:
1. Turnoffyourcomputeranddisconnectthepowercable.
2. Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer.Donotusebothcablesonthesamecomputer. Use both the cables only when they are connected to two different computers with
appropriate video systems.
Connecting the white DVI cable
NOTE: The stand is detached when the monitor is shipped from the factory.
CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions.