User's Manual

Back to Contents Page

Setting Up the Monitor
AlienwareOptX™AW2210User'sGuide
Attaching the Stand
Connecting the Monitor
Organizing the Cables and Attaching the Cable Cover
Removing the Stand
Wall Mounting (Optional)
Attaching the Stand
Remove the monitor cover and place the monitor on it.
1. Fit the two tabs on the upper part of the stand into the grooves on the back of the monitor.
2. Lowerthestandsothatthemonitormountingareasnapsontothestand.
Connecting Your Monitor
To connect your monitor to the computer:
1. Turnoffyourcomputeranddisconnectthepowercable.
2. Connect your monitor to your computer using ONLY ONE of the following cables: the DVI (digital DVI-D) or the HDMI cable. Use both the cables
only when they are connected to two different computers with appropriate video systems.
Connecting the White DVI Cable
OR
Connecting the HDMI Cable
NOTE: The stand is detached from monitor when it is shipped from the factory.

WARNING:Before you begin any of the procedures in this section, follow the Safety Instructions.