Deployment Guide
a. Next to iSCSI Targets, locate the Storage Center iSCSI target IP addresses.
b. Based on these IP addresses, identify the iSCSI subnet (Storage Center fault domain).
c. In the VLAN Tag eld, type the VLAN ID for the subnet (fault domain).
d. From the Interface drop-down menu, select the controller interface that is connected to the iSCSI subnet.
• eth30 / SAN is the upper right port in each controller.
• eth31 / SAN b is the lower right port in each controller.
e. Dene an IP address for each controller by selecting the controller, clicking Edit Settings, and typing an IP address in the
dialog box.
f. Click Next.
The wizard displays connected Storage Center iSCSI target IP addresses for the second iSCSI subnet and automatically
selects the uncongured interface from the Interface drop-down menu.
2. Congure iSCSI HBA IP addresses for the second iSCSI subnet (Storage Center fault domain).
a. Next to iSCSI Targets, locate the Storage Center iSCSI target IP addresses.
b. Based on these IP addresses, identify the iSCSI subnet (Storage Center fault domain).
c. In the VLAN Tag eld, type the VLAN ID for the subnet (fault domain).
d. Dene an IP address for each controller by selecting the controller, click Edit Settings, and type an IP address in the dialog
box.
e. Click Next. The iSCSI ports are congured and the Connectivity Report page opens.
Connectivity Report (iSCSI)
Use the Connectivity Report page to verify iSCSI connectivity between the FluidFS cluster and the Storage Centers.
1. Use the report to verify iSCSI connectivity.
• When the Connectivity Report initially opens, iSCSI logins might still be occurring in the background, causing some or all of
the FluidFS cluster iSCSI initiators to show the status as Not Found/Disconnected. If this status is displayed, wait 30
seconds, then click Refresh to update the report.
Figure 25. Add FluidFS Cluster Wizard — Connectivity Report (Not Found/Disconnected)
• When the iSCSI logins are complete and the report has been refreshed, the status for each FluidFS cluster initiator shows as
Up.
Congure the FluidFS Cluster
37