Users Guide

other updates are applied, the system automatically reboots to complete the BIOS update, and BitLocker is re-
enabled.
● When -autoSuspendBitLocker is set to disable, the CLI removes the BIOS updates from the applicable updates and installs
the rest of the updates. The following warning message is displayed on the console:
Warning: One or more available updates will be skipped, as installing these updates may cause the system to
become locked by BitLocker. To avoid this situation, enable BitLocker suspension and run again to install these
updates.
Command line interface Error codes
Table 6. Following are the generic application return codes:
Return\Error
Codes
Description Resolution
0 Command execution was successful NA
1 A reboot was required from the execution of an operation Reboot the system to complete the
operation.
2 An unknown application error has occurred NA
3 The current system manufacturer is not Dell Dell Command | Update can only be run
on Dell systems.
4 The CLI was not launched with administrative privilege Invoke the Dell Command | Update CLI
with administrative privileges.
5 A reboot was pending from a previous operation Reboot the system to complete the
operation.
6 Another instance of the same application (UI or CLI) is
already running.
Close any running instance of Dell
Command | Update UI or CLI and retry
the operation.
7 The application does not support the current system model Contact your administrator if the current
system model in not supported by the
catalog.
8 No update filters have been applied or configured Supply at least one update filter.
Table 7. The following return codes may appear while evaluating various input validation:
Return\Error
Codes
Description Resolution
100 While evaluating the command line parameters, no
parameters were detected
A command must be specified on the
command line.
101 While evaluating the command line parameters, no
commands were detected
Provide a valid command and options.
Refer Command line interface reference
section, for more information.
102 While evaluating the command line parameters, invalid
commands were detected
Provide a command along with the
supported options for that command.
Refer Command line interface reference
section, for more information.
103 While evaluating the command line parameters, duplicate
commands were detected
Remove any duplicate commands and re-
run the command. Refer Command line
interface reference section, for more
information.
104 While evaluating the command line parameters, the
command syntax was incorrect
Make sure to follow the command
syntax '/<command name>'. Refer
Command line interface reference
section, for more information.
26 Dell Command | Update command-line interface