Users Guide

Default values of Dell Command | Update Settings
The below table provides the default value of Dell Command | Update Settings:
Table 4. General Settings default values
General Settings options Default Value
Download File Location
C:\ProgramData\Dell\UpdateService\Downloads
Update Source Location Default source location from Dell Support Site.
Internet Proxy Use current Internet proxy settings.
User Consent Varies based on the selection during installation. By default,
this option is not selected if the application is installed on the
system when shipped to the user.
Table 5. Update Settings default values
Update Settings options Default value
Check for updates schedule. Varies based on the selection during first launch. It is set to
Automatic Updates if the application is installed on the
system when shipped to the user.
NOTE: The default schedule is every three days when
Automatic Updates are enabled.
When updates are found Notify only
Automatically reboot after Fifteen minutes
Table 6. Update Filter Settings default values
Update Filter Settings options Default value
What to display Updates for this system configuration—recommended.
Customize updates All options selected under Recommendation Level, Update
Type, and Device Category.
Table 7. Advanced Driver Restore default values
Advanced Driver Restore options Default value
Feature Enable Enabled.
NOTE: This feature is disabled by default if the application
is installed on the system.
Driver Library Location Download driver library from Dell support site—recommended.
Table 8. BIOS default values
BIOS options Default value
System password No value
Automatically suspend BitLocker. By default, this option is enabled.
18 Configure Dell Command | Update