Reference Guide

Table 16. PreEnabled (continued)
Attribute Description
Possible values:
● Enabled — Enables the Dell recovery tool.
● Disabled — Disables the Dell recovery tool.
ReportLogoType
Reports the type of splash screen logo (Dell or custom) that is passed from BIOS to
user.
Possible values:
● 0 and 1
NOTE: You cannot enable or disable this feature using Dell Command |
PowerShell Provider.
RuggedDeskDockNicPxe
Enables or disables the support for PXE Boot from Rugged Desk Dock NIC device.
Possible values:
● Enabled
● Disabled
ServiceOSClear
Deletes the service OS non-volatile region.
Possible values:
● Enabled — Deletes the service OS non-volatile region and changes the token
status to Disabled.
● Disabled — Does not delete the service OS non-volatile region.
TelemetryAccessLvl
This feature controls the type of telemetry for data support.
Possible values:
● Disabled — No telemetry
● Basic — Flash and Diags only
● Enhanced — Flash, Diags, and Boot Event
● Full — All telemetry
UsbWakeS4En
Enables or disables the USB wake from s4 power state of the system.
Possible values:
● Enabled — Enables the USB wake from s4 power state of the system.
● Disabled — Disables the USB wake from s4 power state of the system.
ProcessorInformation
Table 17. ProcessorInformation
Attribute Name Description
64-BitTechnology
Specifies whether the installed processors support 64-bit extensions.
Possible values: Read-only
CoreCount
Displays the number of cores in each processor. By default, the maximum number of
cores per processor are enabled.
Possible values: Read-only
CurrentClockSpeed
Displays the current speed of the processor.
Possible values: Read-only
HTCapable
Specifies whether the system supports Hyper Threading (HT).
30 Attributes supported in Dell Command | PowerShell Provider 2.3