Reference Guide

ManualsBrandsDell ManualsAnalyticsCommand | Powershell Provider

SupportAssistSystemResolution

Table 24. SupportAssistSystemResolution

Attribute Description

AutoOSRecoveryThreshold Sets the threshold value for auto OS recovery. Possible values: 0 to 3Controls the

automatic boot flow for SupportAssist System Resolution console and for Dell OS

Recovery Tool. The system boots to the SupportAssist System Resolution console

and for Dell OS Recovery Tool if;

● the primary operating system fails to boot consecutively

● the count of boot failure is greater than or equal to the value of the Auto OS

Recovery threshold setup option

● SupportAssist OS Recovery option is enabled

NOTE: If Auto OS Recovery threshold is set to 0, then all automatic boot flow

for SupportAssist System Resolution console and for Dell OS Recovery Tool

will be disabled.

BiosConnect Enables or Disables BIOS Connect feature. The following are the possible values:

● Enabled

● Disabled

SupportAssistOSRecovery Enables or disables the boot flow for SupportAssist OS recovery tool in the event

of certain system errors. The following are the possible values:

● Enabled

● Disabled

MpmCfg This feature controls the level of monitoring of Memory Performance Monitor

(MPM). MPM monitors the memory for faults and perform fault recovery when

possible. The following are the possible values:

● OFF

● Low

● Med

● High

SystemConfiguration

Table 25. SystemConfiguration

Attribute Name Description

AnalogDigitalInterfaceModeCha

nnel1

Sets the defined Analog or Digital Interface mode for channel 1. The following are the

possible values:

● Unused—Channel is unused.

● ADCInput—Sets the channel mode as Analog-to-Digital Converter (ADC) input.

● DACOutput—Sets the channel mode as Digital-to-Analog Converter (DAC) output.

● DACAndADC—Sets the channel mode as DAC output, but can be monitored through

ADC input.

● GPIO—Sets the channel mode as General Purpose Input or Output.