Reference Guide
Table Of Contents
- Dell Command | PowerShell Provider Version 2.4 Reference Guide
- Introduction to Dell Command | PowerShell Provider 2.4
- Attributes supported in Dell Command | PowerShell Provider 2.4
- AdvancedBootOptions
- AdvancedConfigurations
- BatteryInformation
- BIOSSetupAdvancedMode
- BootSequence
- Connection
- Integrated Devices
- IntelSoftwareGuardExtensions
- Keyboard
- Manageability
- Maintenance
- MemoryInformation
- MiscellaneousDevices
- Passwords
- Performance
- POSTBehavior
- PowerManagement
- PreEnabled
- ProcessorInformation
- SecureBoot
- Security
- StealthModeControl
- SupportAssistSystemResolution
- SystemConfiguration
- SystemInformation
- SystemLogs
- ThermalConfiguration
- TPMSecurity
- USBConfiguration
- Video
- VirtualizationSupport
- Wireless
- Error reporting in Dell Command | PowerShell Provider 2.4
- Accessing documents from the Dell EMC support site
Table 22. Security (continued)
Attribute Name Description
IsAdminPasswordSet Specifies if an admin password has been set. Possible values: True, false (Read-only)
IsSystemPasswordSet Specifies if a system password has been set. Possible values: True, false (Read-only)
MasterPasswordLockout Enables or disables master password settings.
CAUTION: Using the Dell Command | PowerShell Provider, you cannot
disable this feature.
The following are the possible values:
● Enabled—The master password cannot be used to:
○ clear other passwords
○ unlock and access Hard Disk Drive
○ erase data from Hard Disk Drive.
● Disabled—The master password can be used to:
○ clear other passwords
○ unlock and access Hard Disk Drive
○ erase data from Hard Disk Drive.
NOTE: One of the methods of configuring this feature is from the BIOS setup
screen.
NOTE: You cannot enable MasterPasswordLockout while setting up with Hdd or
Owner's password.
NonAdminPsidRevert The following are the possible values:
● Enabled—When enabled, the PSID revert is allowed to proceed without providing
the BIOS admin password.
● Disabled—When disabled, and if the BIOS admin password is set, PSID revert is
protected and the BIOS admin password can be entered before performing the
revert.
NVMePwdFeature This feature enables or disables the NVMe password. The following are the possible
values:
● Enabled
● Disabled
OromKeyboardAccess Determines whether users are able to enter Option ROM Configuration screens using
hotkeys during boot. The following are the possible values:
● Enabled—Users are able to enter OROM configuration screens using hotkeys
during boot.
● OneTimeEnable—Users will be able to enter OROM configuration screens using
hotkeys during next boot only. After next boot, the settings will revert to disabled.
● Disabled—Users are able to enter OROM configuration screens using hotkeys
during boot.
PasswordBypass Allows users to skip the entry of the system password, HDD password, fingerprint
scan, or smartcard on either/both reboot (warm boot) or S3 resume (resume from
standby). The following are the possible values:
● Disabled
● RebootBypass
● ResumeBypass
● RebootAndResumeBypass
PasswordLock Determines whether the changes to the system and HDD passwords are permitted or
restricted if an admin password is set. The following are the possible values:
● Disabled—If disabled, then the system and HDD passwords are locked by admin
password and cannot be set, modified, or deleted unless admin password is
provided.
● Enabled—If enabled, then the system and the HDD passwords can be set,
modified, or deleted.
Attributes supported in Dell Command | PowerShell Provider 2.4 31