Reference Guide

Table 18. PowerManagement (continued)
Attribute Name Description
● Med
● Low
● MedHigh
● MedLow
FanSpeedLvl Configures the fan speed control if the fan speed is set to Auto using FanSpeed attribute.
0 sets the fan speed to the optimal speed level, and a higher percentage provides
enhanced cooling. The following are the possible values: Integers ranging from 0 to 100.
IntelReadyModeEn This option enables or disables Intel Ready Mode Technology (iRMT). The following are the
possible values:
● Enabled
● Disabled
IntlSmartConnect Intel Smart Connect Technology (ISCT) identifies the nearby wireless connections while
system is in a sleeping state. SmartConnect Synchronizes email or social media applications
that were open when the system entered the sleep state. The following are the possible
values:
● Enabled
● Disabled
LidSwitch Enables or disables the lid switch functions. The following are the possible values:
● Enabled—OS setting determines the display behavior when lid is closed.
● Disabled—Display will not be affected when lid is closed.
ModBattChargeCfg Configures the module bay battery charge mode. The following are the possible values:
● Standard—Charges the battery at a standard rate.
● Express—Charges the battery faster using the express charging algorithm, Dell's fast
charging technology
PeakShiftBatteryThreshold Sets the value of the Peak Shift battery threshold. The acceptable value range is from 15
to 100 percent. When the Peak Shift battery threshold level is reached, the system starts
using AC power. The following are the possible values: Integers ranging from 15 to 100.
PeakShiftCfg Enables or disables Peak Shift configuration. Using Peak Shift, you can minimize the
consumption of AC power during the peak power usage period of the day. The following
are the possible values:
● Enabled
● Disabled
PeakShiftDayConfiguration Configures the days settings based on StartTime, EndTime, and ChargeStartTime. Using
Peak Shift configuration, you can minimize the consumption of AC power during the peak
power usage period of the day. You can set a start and end times for the Peak Shift period.
During this period, the system runs on battery if the battery charge is preceding the set
battery threshold value. After the Peak Shift period, the system runs on AC power without
charging the battery. The system functions normally using AC power and recharging the
battery after the specified ChargeStartTime. The following are the possible values:
● Enabled
● Disabled
PowerOnLidOpen Set the PowerOnLidOpen feature. The following are the possible values:
● Enabled—If the feature is set to enabled, the system powers up from the off state
whenever the lid is opened. This system powers on when powered either by the AC
adapter or the system battery.
● Disabled—If the feature is set to disabled, the system does not power up from the off
state whenever the lid is opened.
PowerUsageMode Sets the system power usage modes. The following are the possible values:
● PowerSaver—This mode reduces processor sustained power to enhance battery life
depending on the use case. This mode may impact system performance.
● Balanced—This mode balances performance, noise, temperature, and battery life. The
default option is set to Balanced Mode.
Attributes supported in Dell Command | PowerShell Provider 2.4 23