Reference Guide
Table Of Contents
- Dell Command | PowerShell Provider Version 2.4 Reference Guide
- Introduction to Dell Command | PowerShell Provider 2.4
- Attributes supported in Dell Command | PowerShell Provider 2.4
- AdvancedBootOptions
- AdvancedConfigurations
- BatteryInformation
- BIOSSetupAdvancedMode
- BootSequence
- Connection
- Integrated Devices
- IntelSoftwareGuardExtensions
- Keyboard
- Manageability
- Maintenance
- MemoryInformation
- MiscellaneousDevices
- Passwords
- Performance
- POSTBehavior
- PowerManagement
- PreEnabled
- ProcessorInformation
- SecureBoot
- Security
- StealthModeControl
- SupportAssistSystemResolution
- SystemConfiguration
- SystemInformation
- SystemLogs
- ThermalConfiguration
- TPMSecurity
- USBConfiguration
- Video
- VirtualizationSupport
- Wireless
- Error reporting in Dell Command | PowerShell Provider 2.4
- Accessing documents from the Dell EMC support site
Table 16. Performance (continued)
Attribute Name Description
● Hard disk configuration or partition changes
● Memory capacity over 8GB is installed.
● System or HDD password is enabled.
● A Dell Encryption Accelerator card is installed.
● The BlockSleep setting is enabled.
IntelRapidStartInstantOnDispla
y
Enables or disables displaying the system logo from cache during system resume using
Intel Rapid Start Technology. The following are the possible values:
● Enabled—Displays the system logo from cache during system resume using Intel Rapid
Start Technology.
● Disabled—Does not display the system logo from cache during system resume using
Intel Rapid Start Technology.
IntelSpdSelTech Intel Speed Select Technology allows you to choose up to two additional base frequency
conditions. Cfg 1: TDP Level 3 Cfg 2: TDP Level 4. The following are the possible values:
● Configuration 1
● Configuration 2
IrstTimer Sets the Intel Rapid Start Timer. The value can be specified in minutes ranging from 0 to
999. Specify the Rapid Start timer value as 0 to put the system into a low-power state
immediately after the system transition to a sleep mode. The following are the possible
values: Integer ranging from 0 to 999.
LimitCpuidValue Restricts the maximum CPUID functions supported by the processor. Some operating
system does not complete the installation when more than three CPUID functions are
supported. The following are the possible values:
● Enabled
● Disabled
LogicProc Enables or disables HyperThreading in the processor. The following are the possible
values:
● Enabled
● Disabled
MultiCoreSupport Specifies whether the processor has one or more cores enabled. The performances of
some applications improve with additional cores. The following are the possible values:
● CoresAll—All cores are enabled.
● Cores1—Only one core is enabled.
● Cores2—Two cores are enabled.
● Cores4— Four cores are enabled.
● Cores6— Six cores are enabled.
● Cores8— Eight cores are enabled.
● Cores10—Ten cores are enabled.
● Cores12—Twelve cores are enabled.
● Cores14—Fourteen cores are enabled.
● Cores16—Sixteen cores are enabled.
NodeInterleave Enables or disables memory interleave mode. The following are the possible values:
● Enabled
● Disabled
Speedstep Intel SpeedStep technology that allows the processor to operate at two or more
operating speeds called P-states in ACPI terminology. When disabled, the processor
operates at its maximum frequency. The following are the possible values:
● Disabled
● Enabled
● MaximumPerformance
● MaximumBattery
IsochronousMode Enables or disables System Isochronous mode.
16 Attributes supported in Dell Command | PowerShell Provider 2.4