Reference Guide

BootSequence
Table 6. BootSequence
Attribute Name Description
BootList
Determines the system’s boot mode.
Possible values:
● Uefi — Enables booting to Unified Extensible Firmware Interface (UEFI) capable
operating systems.
● Legacy — (the default) Ensures compatibility with operating systems that do not
support UEFI.
NOTE: Legacy boot mode is not allowed when secure boot is enabled or legacy option
ROM is disabled.
BootSequence
Specifies the order in which a system searches for devices when trying to find an
operating system to boot. The BootSequence option allows users to customize the boot
order and boot ability of boot devices. The UEFI BIOS allows the selection of UEFI boot
paths or Legacy boot devices.
IntelSoftwareGuardExtensions
Table 7. IntelSoftwareGuardExtensions
Attribute Name Description
EnclaveSize Displays the memory allocation size for the Intel Software Guard Extension (SGX)
processor reserved memory.
Possible values:
● 32MB
● 64MB
● 128MB
● 256MB
NOTE: You cannot set the Enclave Reserve Memory Size using the Dell
Command | PowerShell Provider. One of the methods of setting Enclave
Reserve Memory Size is from the BIOS setup screen.
SgxLaunchControl
Sets the Intel Software Guard Extensions Launch Control Policy.
Possible values:
● IntelLocked - Locks SGX to support Intel Enclave Launch Provider.
● RuntimeSelectable - Allows operating system or hypervisor control of
Enclave Launch Provider.
SoftGuardEn
Configures Software Guard Extensions (SGX) feature. You can select Enabled or
SoftControlled if this option is disabled.
Possible values:
● Enabled
● Disabled
● SoftControlled
CAUTION: Using the Dell Command | PowerShell Provider, you cannot
do the following:
● Disable this feature if the current state is Enabled or
SoftControlled
● Enable this feature if the current state is SoftControlled
8 Attributes supported in Dell Command | PowerShell Provider 2.2