Reference Guide
Table Of Contents
- Dell Command | PowerShell Provider Version 2.2 Reference Guide
- Introduction to Dell Command | PowerShell Provider 2.2
- Attributes supported in Dell Command | PowerShell Provider 2.2
- AdvancedBootOptions
- AdvancedConfigurations
- BatteryInformation
- BIOSSetupAdvancedMode
- BootSequence
- IntelSoftwareGuardExtensions
- Manageability
- Maintenance
- MemoryInformation
- MiscellaneousDevices
- Performance
- POSTBehavior
- PowerManagement
- PreEnabled
- ProcessorInformation
- SecureBoot
- Security
- StealthModeControl
- SupportAssistSystemResolution
- SystemConfiguration
- SystemInformation
- SystemLogs
- ThermalConfiguration
- TPMSecurity
- USBConfiguration
- Video
- VirtualizationSupport
- Wireless
- Error reporting in Dell Command | PowerShell Provider 2.2
- Accessing documents from the Dell EMC support site
Table 21. SystemConfiguration (continued)
Attribute Name Description
● Large — Allocates a large region of memory to PCI memory mapped I/O. This
reserves the large device-specific memory regions, but reduces the amount of usable
memory in 32-bit operating system.
PcibusCount
Sets the maximum number of PCI bus counts for the system.
Possible values:
● 64
● 128
● 256
PowerButton
Enables, disables, or partially disables the power button.
Possible values:
● Enabled
● Disabled
● Partial disable
PwrOffWlanStealthMode
Enables or disables PwrOffWlanStealthMode.
Possible values:
● Enabled — Disconnects power from the Intel 8260 Wireless NIC when Stealth Mode
is enabled.
● Disabled — Does not disconnect power from the Intel 8260 Wireless NIC when
Stealth Mode is enabled.
NOTE: Disabling Stealth Mode does not automatically restore the power or
functionality of the card until the next complete boot. This non-standard mode is
available as an option for Stealth Mode control of the Intel 8260 card for the
following use cases: Pre-boot applications, Linux OS, or Windows OS without Dell
recommended drivers.
SfpNic
Enables or disables Small Formfactor Pluggable (SFP) device.
Possible values:
● Disabled — Disables the SFP device.
● Enabled — Enables the SFP device.
● EnabledPxe - Enables the SFP device with PXE support.
Sata0
Enables or disables the first SATA drive controller.
Possible values:
● Enabled
● Disabled
Sata1
Enables or disables the second SATA drive controller.
Possible values:
● Enabled
● Disabled
Sata2
Enables or disables the third SATA drive controller.
Possible values:
● Enabled
● Disabled
Sata3
Enables or disables the fourth SATA drive controller.
Possible values:
Attributes supported in Dell Command | PowerShell Provider 2.2 45