Reference Guide

Table 21. SystemConfiguration (continued)
Attribute Name Description
● Unused — Channel is unused.
● ADCInput — Sets the channel mode as Analog-to-Digital Converter (ADC) input.
● DACOutput — Sets the channel mode as Digital-to-Analog Converter (DAC) output.
● DACAndADC — Sets the channel mode as DAC output, but can be monitored through
ADC input.
● GPIO — Sets the channel mode as General Purpose Input or Output.
CanBus
Enables or disables the Controller Area Network (CAN) Bus.
Possible values:
● Enabled
● Disabled
DisOsdBtn
Enables or disables the On-screen Display (OSD) buttons on an All-In-One system. When
disabled, pressing these buttons has no effect.
Possible values:
● Enabled
● Disabled
DockSupportOnBattery
Enabling DockSupportOnBattery allows you to use the docking station, when AC power is
absent, but only when the battery is preceding a certain charge percentage. The
percentage may change per battery and per platform. For example, the dock may only be
powered when the battery is at 60 percent charge or higher, and when the battery drops
below this level (without AC power) the dock loses power.
Possible values:
● Enabled
● Disabled
DustFilter
Enables or disables the BIOS messages for maintaining the optional dust filter installed in
the computer. BIOS generates a pre-boot reminder to clean or replace the dust filter
based on the interval settings.
Valid Arguments:
Disabled, 15days, 30days, 60days, 90days, 120days, 150days, 180days.
EmbNic1
Controls the state of on-board LAN controller 1.
Possible values:
● Disabled
● Enabled
● EnabledPxe
● OnWithImageServerBoot
● EnabledwithRPLBoot
● EnabledwithISCSIBoot
EmbNic2
Controls the state of on-board LAN controller 2.
Possible values:
● Disabled
● EnabledPXE
● Enabled
● EnabledwithImageServerBoot
● EnabledwithRPLBoot
● EnabledwithISCSIBoot
EmbSataRaid
Configures the operating mode of the integrated SATA hard drive controller.
Possible values:
38 Attributes supported in Dell Command | PowerShell Provider 2.2