Reference Guide

Table 20. (continued)
Attribute Description
Possible values: 0 to 3
Controls the automatic boot flow for SupportAssist System Resolution console
and for Dell OS Recovery Tool. The system boots to the SupportAssist System
Resolution console and for Dell OS Recovery Tool if;
● the primary operating system fails to boot consecutively
● the count of boot failure is greater than or equal to the value of the Auto OS
Recovery threshold setup option
● SupportAssist OS Recovery option is enabled
NOTE: If Auto OS Recovery threshold is set to 0, then all automatic boot flow
for SupportAssist System Resolution console and for Dell OS Recovery Tool
will be disabled.
BiosConnect
Enables or Disables BIOS Connect feature.
Possible values:
● Enabled
● Disabled
SupportAssistOSRecovery
Enables or disables the boot flow for SupportAssist OS recovery tool in the event
of certain system errors.
Possible values:
● Enabled
● Disabled
MpmCfg
This feature controls the level of monitoring of Memory Performance Monitor
(MPM). MPM monitors the memory for faults and perform fault recovery when
possible.
Possible values:
● OFF
● Low
● Med
● High
SystemConfiguration
Table 21. SystemConfiguration
Attribute Name Description
AnalogDigitalInterfaceModeCha
nnel1
Sets the defined Analog or Digital Interface mode for channel 1.
Possible values:
● Unused — Channel is unused.
● ADCInput — Sets the channel mode as Analog-to-Digital Converter (ADC) input.
● DACOutput — Sets the channel mode as Digital-to-Analog Converter (DAC) output.
● DACAndADC — Sets the channel mode as DAC output, but can be monitored through
ADC input.
● GPIO — Sets the channel mode as General Purpose Input or Output.
AnalogDigitalInterfaceModeCha
nnel2
Sets the defined Analog or Digital Interface mode for channel 2.
Possible values:
● Unused — Channel is unused.
36 Attributes supported in Dell Command | PowerShell Provider 2.2