Reference Guide
Table Of Contents
- Dell Command | PowerShell Provider Version 2.2 Reference Guide
- Introduction to Dell Command | PowerShell Provider 2.2
- Attributes supported in Dell Command | PowerShell Provider 2.2
- AdvancedBootOptions
- AdvancedConfigurations
- BatteryInformation
- BIOSSetupAdvancedMode
- BootSequence
- IntelSoftwareGuardExtensions
- Manageability
- Maintenance
- MemoryInformation
- MiscellaneousDevices
- Performance
- POSTBehavior
- PowerManagement
- PreEnabled
- ProcessorInformation
- SecureBoot
- Security
- StealthModeControl
- SupportAssistSystemResolution
- SystemConfiguration
- SystemInformation
- SystemLogs
- ThermalConfiguration
- TPMSecurity
- USBConfiguration
- Video
- VirtualizationSupport
- Wireless
- Error reporting in Dell Command | PowerShell Provider 2.2
- Accessing documents from the Dell EMC support site
Table 18. Security (continued)
Attribute Name Description
● Enabled
● Disabled
AmdTSME
Possible values:
● Enabled - AMD Transparent Secure Memory Encryption (TSME) allows
encryption of contents on the memory DIMMS.
NOTE: For best results while diagnosing potential memory DIMM issues, turn
off this feature prior to running diagnostic functions or tools.
● Disabled - AMD Transparent Secure Memory Encryption (TSME) does not allow
encryption on the memory DIMMS.
CapsuleFirmwareUpdate
Enables or disables BIOS updates via UEFI capsule update packages.
Possible values:
● Enabled
● Disabled
ChasIntrusion
The chassis intrusion switch is a physical switch which triggers an event when the
chassis is opened.
Possible values:
● Enabled — The system detects and reports chassis intrusion events to the
system display on boot-up.
● Disabled — The system does not detect and report the Chassis Intrusion events
to the system display on boot-up.
● SilentEnable — The system detects, but does not report the Chassis Intrusion
events to the system display on boot-up.
ChassisIntrusionStatus
Displays the status of chassis intrusion.
NOTE: Except TripReset, all values are read-only.
Possible values:
● DoorOpen — Indicates that chassis door is open.
● Tripped — Indicates that the chassis door was opened since the last time the
sensor-detection logic was reset.
● DoorClosed — Indicates that chassis door is closed.
● TripReset — Resets the sensor-detection logic to detect the next closed-to-open
transition on the chassis door.
Computrace
This feature allows the users to enable or disable Absolute Software's Computrace
security software BIOS ROM. After this token is written, the state is permanently
maintained (this is a write-once field). This token is for Factory use only. Application
and management software must ignore this token. Write-once permanent is different
from write-once. Write-once is reset on a power cycle and/or chipset reset. Write-
once permanent cannot be reset or change once it is set.
Possible values:
● Disable
● Activate
NOTE: You cannot enable or disable this feature using Dell Command | Configure.
CpuXdSupport
Enables or disables the run disable mode of the processor. The operating system can
use this feature to hinder software that exploits buffer overflows.
Possible values:
● Enabled
● Disabled
Attributes supported in Dell Command | PowerShell Provider 2.2 31