Reference Guide
Table Of Contents
- Dell Command | PowerShell Provider Version 2.2 Reference Guide
- Introduction to Dell Command | PowerShell Provider 2.2
- Attributes supported in Dell Command | PowerShell Provider 2.2
- AdvancedBootOptions
- AdvancedConfigurations
- BatteryInformation
- BIOSSetupAdvancedMode
- BootSequence
- IntelSoftwareGuardExtensions
- Manageability
- Maintenance
- MemoryInformation
- MiscellaneousDevices
- Performance
- POSTBehavior
- PowerManagement
- PreEnabled
- ProcessorInformation
- SecureBoot
- Security
- StealthModeControl
- SupportAssistSystemResolution
- SystemConfiguration
- SystemInformation
- SystemLogs
- ThermalConfiguration
- TPMSecurity
- USBConfiguration
- Video
- VirtualizationSupport
- Wireless
- Error reporting in Dell Command | PowerShell Provider 2.2
- Accessing documents from the Dell EMC support site
Table 15. PreEnabled (continued)
Attribute Description
● 0 and 1
NOTE: You cannot enable or disable this feature using Dell Command |
PowerShell Provider.
RuggedDeskDockNicPxe
Enables or disables the support for PXE Boot from Rugged Desk Dock NIC device.
Possible values:
● Enabled
● Disabled
ServiceOSClear
Deletes the service OS non-volatile region.
Possible values:
● Enabled — Deletes the service OS non-volatile region and changes the token
status to Disabled.
● Disabled — Does not delete the service OS non-volatile region.
UsbWakeS4En
Enables or disables the USB wake from s4 power state of the system.
Possible values:
● Enabled — Enables the USB wake from s4 power state of the system.
● Disabled — Disables the USB wake from s4 power state of the system.
ProcessorInformation
Table 16. ProcessorInformation
Attribute Name Description
64-BitTechnology
Specifies whether the installed processors support 64-bit extensions.
Possible values: Read-only
CoreCount
Displays the number of cores in each processor. By default, the maximum number of
cores per processor are enabled.
Possible values: Read-only
CurrentClockSpeed
Displays the current speed of the processor.
Possible values: Read-only
HTCapable
Specifies whether the system supports Hyper Threading (HT).
Possible values: Read-only
MaximumClockSpeed
Displays the maximum speed supported by the processor.
Possible values: Read-only
ProcessorID
Displays the processor ID that contains the processor-specific information that describes
the features of the processor.
Possible values: Read-only
ProcessorL2Cache
Displays the L2 cache size.
Possible values: Read-only
ProcessorL3Cache
Displays the L3 cache size.
Possible values: Read-only
Attributes supported in Dell Command | PowerShell Provider 2.2 29