Reference Guide
Table Of Contents
- Dell Command | PowerShell Provider Version 2.2 Reference Guide
- Introduction to Dell Command | PowerShell Provider 2.2
- Attributes supported in Dell Command | PowerShell Provider 2.2
- AdvancedBootOptions
- AdvancedConfigurations
- BatteryInformation
- BIOSSetupAdvancedMode
- BootSequence
- IntelSoftwareGuardExtensions
- Manageability
- Maintenance
- MemoryInformation
- MiscellaneousDevices
- Performance
- POSTBehavior
- PowerManagement
- PreEnabled
- ProcessorInformation
- SecureBoot
- Security
- StealthModeControl
- SupportAssistSystemResolution
- SystemConfiguration
- SystemInformation
- SystemLogs
- ThermalConfiguration
- TPMSecurity
- USBConfiguration
- Video
- VirtualizationSupport
- Wireless
- Error reporting in Dell Command | PowerShell Provider 2.2
- Accessing documents from the Dell EMC support site
Table 12. Performance (continued)
Attribute Name Description
● System or HDD password is enabled.
● A Dell Encryption Accelerator card is installed.
● The BlockSleep setting is enabled.
IntelRapidStartInstantOnDispla
y
Enables or disables displaying the system logo from cache during system resume using
Intel Rapid Start Technology.
Possible values:
● Enabled — Displays the system logo from cache during system resume using Intel
Rapid Start Technology.
● Disabled — Does not display the system logo from cache during system resume using
Intel Rapid Start Technology.
IntelSpdSelTech
Intel Speed Select Technology allows you to choose up to two additional base frequency
conditions.
Cfg 1: TDP Level 3
Cfg 2: TDP Level 4
Possible values:
● Configuration 1
● Configuration 2
IrstTimer
Sets the Intel Rapid Start Timer. The value can be specified in minutes ranging from 0 to
999. Specify the Rapid Start timer value as 0 to put the system into a low-power state
immediately after the system transition to a sleep mode.
Possible values: Integer ranging from 0 to 999
LimitCpuidValue
Restricts the maximum CPUID functions supported by the processor. Some operating
system does not complete the installation when more than three CPUID functions are
supported.
Possible values:
● Enabled
● Disabled
LogicProc
Enables or disables HyperThreading in the processor.
Possible values:
● Enabled
● Disabled
MultiCoreSupport
Specifies whether the processor has one or more cores enabled. The performances of
some applications improve with additional cores.
Possible values:
● CoresAll — All cores are enabled.
● Cores1 — Only one core is enabled.
● Cores2 — Two cores are enabled.
● Cores4— Four cores are enabled.
● Cores6— Six cores are enabled.
● Cores8— Eight cores are enabled.
● Cores10 — Ten cores are enabled.
● Cores12 — Twelve cores are enabled.
● Cores14 — Fourteen cores are enabled.
● Cores16 — Sixteen cores are enabled.
NodeInterleave
Enables or disables memory interleave mode.
Attributes supported in Dell Command | PowerShell Provider 2.2 15