Reference Guide

SupportAssistSystemResolution
Table 21.
Attribute Description
AutoOSRecoveryThreshold
Sets the threshold value for auto OS recovery.
Possible values: 0 to 3
Controls the automatic boot flow for SupportAssist System Resolution console and for
Dell OS Recovery Tool. The system boots to the SupportAssist System Resolution
console and for Dell OS Recovery Tool if;
• the primary operating system fails to boot consecutively
• the count of boot failure is greater than or equal to the value of the Auto OS
Recovery threshold setup option
• SupportAssist OS Recovery option is enabled
NOTE: If Auto OS Recovery threshold is set to 0, then all automatic boot
flow for SupportAssist System Resolution console and for Dell OS Recovery
Tool will be disabled.
BiosConnect
Enables or Disables BIOS Connect feature.
Possible values:
• Enabled
• Disabled
SupportAssistOSRecovery
Enables or disables the boot flow for SupportAssist OS recovery tool in the event of
certain system errors.
Possible values:
• Enabled
• Disabled
MpmCfg
This feature controls the level of monitoring of Memory Performance Monitor (MPM).
MPM monitors the memory for faults and perform fault recovery when possible.
Possible values:
• OFF
• Low
• Med
• High
SystemConfiguration
Table 22. SystemConfiguration
Attribute Name Description
AnalogDigitalInterfaceModeChann
el1
Sets the defined Analog or Digital Interface mode for channel 1.
Possible values:
• Unused—Channel is unused.
• ADCInput—Sets the channel mode as Analog-to-Digital Converter (ADC) input.
• DACOutput—Sets the channel mode as Digital-to-Analog Converter (DAC) output.
• DACAndADC—Sets the channel mode as DAC output, but can be monitored through ADC
input.
• GPIO—Sets the channel mode as General Purpose Input or Output.
36 Attributes supported in Dell Command | PowerShell Provider 2.3