Reference Guide

Attribute Name Description
reset on a power cycle and/or chipset reset. Write-once permanent cannot be reset or
change once it is set.
Possible values:
• Disable
• Activate
NOTE: You cannot enable or disable this feature using Dell Command |
Configure.
CpuXdSupport
Enables or disables the run disable mode of the processor. The operating system can use
this feature to hinder software that exploits buffer overflows.
Possible values:
• Enabled
• Disabled
GeneralPurposeEncryption
Enables or disables general-purpose encryption.
Possible values:
• Enabled
• Disabled
HDDInfo
Displays the details of each HDD. The following information is displayed:
• HDDName — The name of the HDD.
• Present — Whether the HDD is physically present.
• PwdProtected — Whether a password exists for the HDD.
• PendingRestart — Whether a reboot is pending to set the password.
• AdminOnlyChange — Whether the changes to the password can be made only by an
administrator.
• SecureEraseSupported — Whether HDD Secure Erase is supported.
• SecureEraseEnabled — Whether HDD Secure Erase is enabled.
Possible values: Read-only
HDDPassword
Sets, changes, or clears the HDD password. Enter the HDD password, if set, when the
system is powered on.
NOTE: After setting the HDD password, restart the system.
Possible values: String containing minimum 1 and maximum 32 characters including
whitespace.
HddProtection
Lets the user choose loading of HDD Protection OPROM.
IntlPlatformTrust
Enables or disables IntlPlatformTrust feature.
Possible values:
• Enabled — Displays the Intel Platform Trust Technology (PTT) device from the
operating system on the next boot.
• Disabled — Hides the Intel Platform Trust Technology (PTT) device from the operating
system on the next boot.
NOTE: When disabled, the PTT device is not displayed to the operating system,
and no changes can be made to the PTT device or its content.
IsAdminPasswordSet
Specifies if an admin password has been set.
Possible values: True, false (Read-only)
IsSystemPasswordSet
Specifies if a system password has been set.
Possible values: True, false (Read-only)
32 Attributes supported in Dell Command | PowerShell Provider 2.3