Reference Guide

Attribute Name Description
• Custom — Charges the battery in Express Charge mode using the express charging algorithm,
Dell's fast charging technology.
Speedshift
Enables or disables the Intel Speed Shift Technology support. Setting this option to Enabled allows
the operating system to select the appropriate processor performance automatically.
Possible values:
• Enabled
• Disabled
TypeCPower
Configures the maximum power for type-C connector.
Possible values:
• 7.5W
• 15W
UsbWake
Enables USB devices to wake the system from Standby.
NOTE: This feature is functional only when the AC power adapter is connected.
Possible values:
• Enabled
• Disabled
WakeOnAc
Controls the system's behavior when AC power is restored after AC power was lost.
Possible values:
• Disabled — System stays off after AC power is restored.
• Enabled — System powers on after AC power is restored.
WakeOnDock
Enables or disables waking the system when a docking connection is made.
Possible values:
• Enabled
• Disabled
WakeOnLan
Configures the wake-on-LAN feature.
Possible values:
• LanOnly — The system wake-on-LAN feature is enabled; either an onboard or an add-in NIC
can wake the system up.
• Disabled — Does not allow the system to power on when it receives a wakeup signal from the
LAN or wireless LAN.
• AddInCard — Enables NICs, plugged into the power connector, as the source of any wake-on-
LAN signal.
• WlanOnly — Allows the system to be powered on by special WLAN signal.
• LanWlan — Allows the system to be powered on by special LAN or wireless LAN signal.
• AddInCard — Allows the system to be powered on by NICs plugged into the special power
connector.
• Onboard — Allows the system to be powered on by Onboard NIC.
• LanWithPxeBoot — Enables the network controller and wakes up the system to boot the PXE
when a wake packet is sent to the system in the S4 or S5 state.
• SfpNic — Allows the system to wake-up by certain SFP signals.
• LanOrSfpNic — Allows the system to wake-up either by LAN, or by SFP signals.
• SfpNicWithPxeBoot — Allows the system to wake-up by SFP signals, and immediately boot to
PXE.
WakeOnLan2
Defines the wake-on-LAN2 feature.
26 Attributes supported in Dell Command | PowerShell Provider 2.3