Reference Guide

Attribute Name Description
Possible values:
• Enabled
• Disabled
DynTunML
Enables operating system capability to enhance dynamic power tuning capabilities based on
detected workloads.
Protections for exposure: The –Admin password restricts editing the command –Removed in
case when you are using command line interface.
Possible values:
• Enabled
• Disabled
EnableMultiCoreSupport
Enables or disables multiple CPU cores.
Possible values:
• Enabled — The operating system is allowed to access additional cores present on a single
CPU package.
• Disabled — The operating system is prevented to access additional cores present on a single
CPU package.
HwPrefetcher
Enables or disables the CPU's hardware prefetcher. If enabled, the processor's Hardware
Prefetcher will automatically prefetch data and code for the processor.
Possible values:
• Enabled
• Disabled
IntelRapidStart
Enables or disables the Intel Rapid Start feature. The Intel Rapid Start feature reduces power
consumption by putting the system into a low-power state during sleep mode after the specified
amount of time (minutes). The resume time may be slightly more than resuming the system from
a sleep mode, but less than resuming from a hibernate mode.
Intel Rapid Start Technology is automatically be disabled due to configuration changes, such as:
• Hard disk configuration or partition changes
• Memory capacity over 8GB is installed.
• System or HDD password is enabled.
• A Dell Encryption Accelerator card is installed.
• The BlockSleep setting is enabled.
IntelRapidStartInstantOnDisplay
Enables or disables displaying the system logo from cache during system resume using Intel Rapid
Start Technology.
Possible values:
• Enabled — Displays the system logo from cache during system resume using Intel Rapid
Start Technology.
• Disabled — Does not display the system logo from cache during system resume using Intel
Rapid Start Technology.
IntelSpdSelTech
Intel Speed Select Technology allows you to choose up to two additional base frequency
conditions.
Cfg 1: TDP Level 3
Cfg 2: TDP Level 4
Possible values:
• Configuration 1
• Configuration 2
Attributes supported in Dell Command | PowerShell Provider 2.3 15