Reference Guide

Attribute Name Description
• Enabled — BIOS checks the BIOS image integrity during every booting process.
• Disabled — BIOS checks the BIOS image integrity only if the previous booting process did
not complete.
NOTE: BIOS checks the BIOS image integrity only if the BiosAutoRcvr option is
enabled.
BiosRcvrFrmHdd
Enables or disables the system BIOS Recovery option. This feature saves a recovery image to a
primary hard disk drive storage, or to an external USB, and uses this recovery image to recover
the BIOS image when system BIOS fails.
Possible values:
• Enabled — BIOS stores the recovery image on a primary hard disk drive storage. So the BIOS
recovery image is available both from the primary hard disk drive permanent storage and via
an external USB.
• Disabled — BIOS does not store the recovery image on primary hard disk drive storage. So
the BIOS recovery image is available only via an external USB.
Serr
Enables or disables the SERR on the DRAM controller and the PEG controller in the north bridge.
Possible values:
• Disabled — Disable the SERR DMI messaging mechanism.
• Enabled — Allows SERR messages to be generated.
MemoryInformation
Table 10. MemoryInformation
Attribute Name Description
DIMMASize
Displays the amount of main memory physically installed in the DIMM slot A.
Possible Values: Read-only
DIMMBSize
Displays the amount of main memory physically installed in the DIMM slot B.
Possible Values: Read-only
DIMMCSize
Displays the amount of main memory physically installed in the DIMM slot C.
Possible Values: Read-only
DIMMDSize
Displays the amount of main memory physically installed in the DIMM slot D.
Possible Values: Read-only
MemoryAvailable
Displays the amount of main memory available to the operating system.
NOTE: Due to an amount of memory allocated for the system use, MemoryAvailable
is less than MemoryInstalled. Certain operating systems may not be able to use all
the available memory.
Possible Values: Read-only
MemoryInstalled
Displays the amount of main memory physically installed in the system.
Possible Values: Read-only
MemorySpeed
Displays the clock frequency of the main memory.
Possible Values: Read-only
MemoryTechnology
Displays the technology of the main memory installed in the system.
Possible Values: Read-only
10 Attributes supported in Dell Command | PowerShell Provider 2.3