Reference Guide

Attribute Name Description
• GPIO — Sets the channel mode as General Purpose Input or Output.
AnalogDigitalInterfaceModeChannel
7
Sets the dened Analog or Digital Interface mode for channel 7.
Possible values:
• Unused — Channel is unused.
• ADCInput — Sets the channel mode as Analog-to-Digital Converter (ADC) input.
• DACOutput — Sets the channel mode as Digital-to-Analog Converter (DAC) output.
• DACAndADC — Sets the channel mode as DAC output, but can be monitored through ADC
input.
• GPIO — Sets the channel mode as General Purpose Input or Output.
AnalogDigitalInterfaceModeChannel
8
Sets the dened Analog or Digital Interface mode for channel 8.
Possible values:
• Unused — Channel is unused.
• ADCInput — Sets the channel mode as Analog-to-Digital Converter (ADC) input.
• DACOutput — Sets the channel mode as Digital-to-Analog Converter (DAC) output.
• DACAndADC — Sets the channel mode as DAC output, but can be monitored through ADC
input.
• GPIO — Sets the channel mode as General Purpose Input or Output.
CanBus
Enables or disables the Controller Area Network (CAN) Bus.
Possible values:
• Enabled
• Disabled
DisOsdBtn
Enables or disables the On-screen Display (OSD) buttons on an All-In-One system. When
disabled, pressing these buttons has no eect.
Possible values:
• Enabled
• Disabled
DockSupportOnBattery
Enabling DockSupportOnBattery allows you to use the docking station, when AC power is
absent, but only when the battery is preceding a certain charge percentage. The percentage may
change per battery and per platform. For example, the dock may only be powered when the
battery is at 60 percent charge or higher, and when the battery drops below this level (without
AC power) the dock loses power.
Possible values:
• Enabled
• Disabled
DustFilter
Enables or disables the BIOS messages for maintaining the optional dust lter installed in the
computer. BIOS generates a pre-boot reminder to clean or replace the dust lter based on the
interval settings.
Valid Arguments:
Disabled, 15days, 30days, 60days, 90days, 120days, 150days, 180days.
EmbNic1
Controls the state of on-board LAN controller 1.
40 Attributes supported in Dell Command | PowerShell Provider 2.2