Reference Guide

Attribute Name Description
• LanWithPxeBoot — Enables the network controller and wakes up the system to boot the PXE
when a wake packet is sent to the system in the S4 or S5 state.
• SfpNic — Allows the system to wake-up by certain SFP signals.
• LanOrSfpNic — Allows the system to wake-up either by LAN, or by SFP signals.
• SfpNicWithPxeBoot — Allows the system to wake-up by SFP signals, and immediately boot to
PXE.
WakeOnLan2
Denes the wake-on-LAN2 feature.
• LanOnly — The system wake-on-LAN feature is enabled; either an onboard or an add-in NIC
can wake up the system.
• Disabled — The system does not respond to magic packets or other means of wake-on-LAN.
The NIC chip section that looks for packets will not be powered.
• LanWithPxeBoot — Enables the network controller and causes the system to wake up and
immediately boot to PXE when a wake packet is sent to the system in the S4 or S5 state.
WlanAutoSense
Enables or disables the WLAN radio when the system is connected to a wired network. When
disconnected from the wired network, WLAN radio is re-enabled.
Possible values:
• Enabled
• Disabled
WwanAutoSense
Enables or disables the WWAN radio when the system is connected to a wired network. When
disconnected from the wired network, WWAN radio is re-enabled.
Possible values:
• Enabled
• Disabled
PreEnabled
Table 15. PreEnabled
Attribute Description
AmdSmartShift
Sets the AmdSmartShift.
Possible values:
• Enabled - On a discrete GPU system, AMD SmartShift allows the system’s CPU and
discrete GPU to share the power limits. This allows the potential performance that
increases within the systems power or thermal limitation,
• Disabled - AmdSmartShift feature disabled.
.
BiosConnectActivation
Congures the state of the available BiosConnect boot paths.
Possible values:
• Deactivate — BIOS setup options are not available and all BiosConnect boot paths are
disabled.
• FullActivation — BIOS Setup options are enabled and all BiosConnect boot paths are
enabled.
• LaunchpadActivationOnly — BIOS setup options are enabled and only launchpad code
path is enabled.
28 Attributes supported in Dell Command | PowerShell Provider 2.2