Reference Guide

Attribute Name Description
Possible values:
• Enabled - If the feature is set to enabled, the system powers up from the o state whenever
the lid is opened. This system powers on when powered either by the AC adapter or the system
battery.
• Disabled - If the feature is set to disabled, the system does not power up from the o state
whenever the lid is opened.
PowerUsageMode Sets the system power usage modes.
Possible values:
• PowerSaver - This mode reduces processor sustained power to enhance battery life depending
on the use case. This mode may impact system performance.
• Balanced - This mode balances performance, noise, temperature, and battery life. The default
option is set to Balanced Mode.
• Performance - This mode uses the processor's typical power and utilizes discrete graphics.
• HighPerformance - This mode increases processor sustained power to produce higher system
performance, but produces more noise, increases system surface temperature, and reduces the
battery life.
PrimaryBattChargeCfg
Congures the primary battery charge mode. The selected charging mode applies to all batteries
installed in the system.
Possible values:
• Adaptive — Battery settings are adoptively optimized based on your typical battery usage
pattern.
• Standard — Charges the battery at a standard rate.
• Express — Charges the battery faster using the express charging algorithm, Dell's fast
charging technology.
• PrimAcUse — Charges the battery while plugged in, a mode preferred by the users who
operate their systems while plugged in to an external power source.
• Custom — The battery charging starts and stops based on user settings specied in Primary
Battery Custom Charge Start and Primary Battery Custom Charge End.
SfpwakeOnLan
Enables the system to power on by a special LAN signal, or by a special SFP signal.
Possible values:
• SFP - Allows the system to be powered on by special SFP signals.
• LANSFP - Allows the system to be powered on by either by LAN, or by SFP signals.
• SFPPXE - Allows the system to be powered on by SFP signals, and immediately boot to PXE.
NOTE: This feature works only if the system is connected to AC power.
SleepMode
Determines which sleep mode to be used by the operating system.
NOTE: The BIOS can only support either Modern Standby sleep mode (connected or
disconnected), or S3 sleep mode.
Possible values:
• OSAutoSelection — Allows the operating system to select the appropriate sleep mode
automatically.
• ForceS3 — Forces the operating system to use the S3 sleep mode only.
SliceBattChargeCfg Congures the battery slice charging feature.
Possible values:
• Standard — The battery is charged over a long period of time.
• Express — Charges the battery in Express Charge mode using the express charging algorithm,
Dell's fast charging technology.
26 Attributes supported in Dell Command | PowerShell Provider 2.2