Reference Guide
Attribute Name Description
Possible values:
• Enabled
• Disabled
AutoOnThur
Enables or disables the AutoOn functionality at the specied time on Thursdays.
Possible values:
• Enabled
• Disabled
AutoOnFri
Enables or disables the AutoOn functionality at the specied time on Fridays.
Possible values:
• Enabled
• Disabled
AutoOnSat
Enables or disables the AutoOn functionality at the specied time on Saturdays.
Possible values:
• Enabled
• Disabled
AutoWakePeriod
Denes the time in minutes after which the system should automatically wake up from Standby,
Hibernate, or Switched o mode.
Possible values: integers ranging from 0 to 254
NOTE: The system wakes up from Sleep, Hibernate, or Switched o mode only if the
AutoOn option is enabled for everyday of the week.
BlinkPowerSupply1LED
Normally, the status LEDs on the back of the Power Supply Unit (PSU) displays solid green color.
Possible values:
• Enabled — The rst power supply (PSU 1) status LED blinks for few seconds.
NOTE: There is no need for disabling the LEDs manually. When the Embedded Controller
(EC) gives the control back to PSU, the LED turns o automatically.
BlinkPowerSupply2LED
Normally, the status LEDs on the back of the Power Supply Unit (PSU) displays solid green color.
Possible values:
• Enabled — The second power supply (PSU 2) status LED blinks for few seconds.
NOTE: There is no need for disabling the LEDs manually. When the Embedded Controller
(EC) gives the control back to PSU, the LED turns o automatically.
BlockSleep
Blocks the system entering sleep (S3 state) mode in an OS environment. If enabled, the system
does not go into sleep mode, Intel Rapid Start is disabled automatically, and OS Power option is
blank if it was set to Sleep earlier.
Possible values:
• Enabled
• Disabled
CustomChargeStart
Sets the percentage value ranging from 50 to 95 at which custom battery charging should start.
Attributes supported in Dell Command | PowerShell Provider 2.2 23