Reference Guide

Category Name Description

Wireless Displays the attributes to configure wireless devices.

AdvancedBootOptions

Table 2. AdvancedBootOptions

Attribute Name Description

AttemptLegacyBoot

Determines if BIOS should attempt to boot from the legacy boot list when the UEFI boot list

fails.

Possible values:

• Enabled - If the UEFI boot list fails, then BIOS attempts to boot from the Legacy boot list.

• Disabled - BIOS discontinues the booting process if the UEFI boot list fails.

LegacyOrom

If enabled, allows legacy option ROMs to load. Without this option, only UEFI option ROMs

loads. This option is required for Legacy boot mode. This mode cannot be enabled with

Secure Boot.

Possible values:

• Enabled

• Disabled

UefiBootPathSecurity

Determines whether the system should prompt the user to enter the Admin password, if set,

while booting from a UEFI boot path from the F12 Boot Menu.

Possible values:

• AlwaysExceptInternalHdd — All UEFI boot paths require the user to enter the Admin

password, except for the boot paths that are hosted on an internal hard disk drives.

• Always — Booting from any UEFI boot path requires the user to enter the Admin

password.

• Never — The Admin password is not required for booting from UEFI boot paths.

AdvancedConfigurations

Table 3. AdvancedConfigurations

Attribute Name Description

Aspm

Set the ASPM (Active State Power Management) level.

Possible values:

• Auto — There is handshaking between the device and PCI Express hub to determine

the best ASPM mode supported by the device.

• Disabled — ASPM power management is turned off always.

• L1 — ASPM power management is set to use L1.