Reference Guide

Attribute Name Description
• Disabled — Display will not be affected when lid is closed.
ModBattChargeCfg
Configures the module bay battery charge mode.
Possible values:
• Standard — Charges the battery at a standard rate.
• Express — Charges the battery faster using the express charging algorithm, Dell's fast
charging technology
PeakShiftBatteryThreshold
Sets the value of the Peak Shift battery threshold. The acceptable value range is from 15 to
100 percent. When the Peak Shift battery threshold level is reached, the system starts using
AC power.
Possible values: Integers ranging from 15 to 100
PeakShiftCfg
Enables or disables Peak Shift configuration. Using Peak Shift, you can minimize the
consumption of AC power during the peak power usage period of the day.
Possible values:
• Enabled
• Disabled
PeakShiftDayConfiguration
Configures the days settings based on StartTime, EndTime, and ChargeStartTime. Using Peak
Shift configuration, you can minimize the consumption of AC power during the peak power
usage period of the day. You can set a start and end times for the Peak Shift period. During
this period, the system runs on battery if the battery charge is preceding the set battery
threshold value. After the Peak Shift period, the system runs on AC power without charging
the battery. The system functions normally using AC power and recharging the battery after
the specified ChargeStartTime.
Possible values:
• Enabled
• Disabled
PrimaryBattChargeCfg
Configures the primary battery charge mode. The selected charging mode applies to all
batteries installed in the system.
Possible values:
• Adaptive — Battery settings are adoptively optimized based on your typical battery usage
pattern.
• Standard — Charges the battery at a standard rate.
• Express — Charges the battery faster using the express charging algorithm, Dell's fast
charging technology.
• PrimAcUse — Charges the battery while plugged in, a mode preferred by the users who
operate their systems while plugged in to an external power source.
• Custom — The battery charging starts and stops based on user settings specified in
Primary Battery Custom Charge Start and Primary Battery Custom Charge End.
SfpwakeOnLan
Enables the system to power on by a special LAN signal, or by a special SFP signal.
Possible values:
• SFP - Allows the system to be powered on by special SFP signals.
• LANSFP - Allows the system to be powered on by either by LAN, or by SFP signals.
• SFPPXE - Allows the system to be powered on by SFP signals, and immediately boot to
PXE.
22