Reference Guide
Attribute Name Description
AutoOnFri
Enables or disables the AutoOn functionality at the specified time on Fridays.
Possible values:
• Enabled
• Disabled
AutoOnSat
Enables or disables the AutoOn functionality at the specified time on Saturdays.
Possible values:
• Enabled
• Disabled
BlinkPowerSupply1LED
Normally, the status LEDs on the back of the Power Supply Unit (PSU) displays solid green
color.
Possible values:
• Enabled — The first power supply (PSU 1) status LED blinks for few seconds.
NOTE: There is no need for disabling the LEDs manually. When the Embedded
Controller (EC) gives the control back to PSU, the LED turns off automatically.
BlinkPowerSupply2LED
Normally, the status LEDs on the back of the Power Supply Unit (PSU) displays solid green
color.
Possible values:
• Enabled — The second power supply (PSU 2) status LED blinks for few seconds.
NOTE: There is no need for disabling the LEDs manually. When the Embedded
Controller (EC) gives the control back to PSU, the LED turns off automatically.
BlockSleep
Blocks the system entering sleep (S3 state) mode in an OS environment. If enabled, the
system does not go into sleep mode, Intel Rapid Start is disabled automatically, and OS Power
option is blank if it was set to Sleep earlier.
Possible values:
• Enabled
• Disabled
CustomChargeStart
Sets the percentage value ranging from 50 to 95 at which custom battery charging should
start.
NOTE: Primary Battery Custom Charge Start percent must be less than the Primary
Battery Custom Charge End percent and the minimum difference between the two
must be 5 percent.
Possible values: Integers ranging from 50 to 95
CustomChargeStop
Sets the percentage value ranging from 55 to 100 at which the custom battery charging
should stop.
NOTE: Primary Battery Custom Charge Start percentage must be less than the
Primary Battery Custom Charge End percent and the minimum difference between
the two must be 5 percent.
Possible values: Integers ranging from 55 to 100
DeepSleepCtrl
Controls when Deep Sleep is enabled.
20