Reference Guide

Attribute Name Description
WakeonLANorWLAN
Enables the system to turn on from the off state when triggered by a
special LAN signal, or from the hibernate state when triggered by a special
wireless LAN signal.
Possible values:
• Enabled — Allows the system to power on when it receives a wakeup
signal from the LAN or wireless LAN.
• Disabled — Does not allow the system to power on when it receives a
wakeup signal from the LAN or wireless LAN.
• LAN only — Allows the system to be powered on by special LAN signal.
• WLAN only — Allows the system to be powered on by special WLAN
signal.
• LAN or WLAN — Allows the system to be powered on by special LAN or
wireless LAN signal.
BlockSleepS3State
Blocks the system entering sleep (S3 state) mode in an OS environment. If
enabled, the system does not go into sleep mode, Intel Rapid Start is
disabled automatically, and OS Power option is blank if it was set to Sleep
earlier.
Possible values:
• Enabled
• Disabled
PrimaryBatteryChargeCon
figuration
Configures the primary battery charge mode. The selected charging mode
applies to all batteries installed in the system.
Possible values:
• Adaptive — Battery settings are adaptively optimized based on your
typical battery usage pattern.
• Standard — Charges the battery at a standard rate.
• ExpressCharge — Charges the battery faster using the express charging
algorithm, Dell's fast charging technology.
• Primarily AC Use — Charges the battery while plugged in, a mode
preferred by the users who operate their systems while plugged in to
an external power source.
• Custom — The battery charging starts and stops based on user settings
specified in Primary Battery Custom Charge Start and Primary Battery
Custom Charge End.
PrimaryBatteryCustomCh
argeStart
Sets the percentage value ranging from 50 to 95 at which custom battery
charging should start.
NOTE: Primary Battery Custom Charge Start percent must be less
than Primary Battery Custom Charge End percent and the minimum
difference between the two must be 5 percent.
Possible values: Integers ranging from 50 to 95
PrimaryBatteryCustomCh
argeEnd
Sets the percentage value ranging from 55 to 100 at which the custom
battery charging should stop.
26