Reference Guide

Table 19. RemoteServiceAccessPoint (continued)
Property Description
● 5 = IPX Address
● 6 = DECnet Address
● 7 = SNA Address
● 8 = Autonomous System Number
● 9 = MPLS Label
● 10 = IPv4 Subnet Address
● 11 = IPv6 Subnet Address
● 12 = IPv4 Address Range
● 13 = IPv6 Address Range
● 100 = Dial String
● 101 = Ethernet Address
● 102 = Token Ring Address
● 103 = ATM Address
● 104 = Frame Relay Address
● 200 = URL 201 = FQDN
● 202 = User FQDN
● 203 = DER ASN1 DN
● 204 = DER ASN1 GN
● 205 = Key ID .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
Name
The Name property uniquely identifies the ServiceAccessPoint
and provides an indication of the functionality that is
managed. This functionality is described in more detail in the
Description property of the object.
RequestedState
An integer enumeration that indicates the last requested or
desired state for the element, irrespective of the mechanism
through which it was requested. The actual state of the
element is represented by EnabledState. This property is
provided to compare the last requested and current enabled
or disabled states.
NOTE: When EnabledState is set to 5 (Not Applicable),
then this property has no meaning. See the EnabledState
property description for explanations of the values in the
RequestedState enumeration.
NOTE: The value No Change (5) has been deprecated
instead of indicating the last requested state is Unknown
(0). If the last requested or desired state is unknown,
RequestedState should have the value Unknown (0), but
may have the value No Change (5).
There are two new values in RequestedState that build on the
statuses of EnabledState. These are Reboot (10) and Reset
(11).
Shut Down requests an orderly transition to the Disabled
state, and may involve removing power, to completely erase
any existing state. The Disabled state requests an immediate
disabling of the element, such that it will not execute or
accept any commands or processing requests. This property is
set as the result of a method invocation (such as Start or
StopService on CIM_Service), or can be overridden and
defined as WRITEable in a subclass. The method approach is
considered superior to a WRITEable property, because it
allows an explicit invocation of the operation and the return of
a result code. If knowledge of the last RequestedState is not
70
Dell Command | Monitor 10.3 classes and properties