Reference Guide

Table Of Contents
Table 11. IPProtocolEndpoint (continued)
Property Description
EnabledState
An integer enumeration that indicates the enabled and
disabled states of an element. It can also indicate the
transitions between these requested states.
Possible values are:
0 = Unknown
1 = Other
2 = Enabled Indicates that the element is or could be
executing commands, will process any queued commands,
and queues new requests.
3 = Disabled Indicates that the element will not execute
commands and will drop any new requests.
4 = Shutting Down Indicates that the element is in the
process of going to a Disabled state.
5 = Not Applicable Indicates the element does not
support being enabled or disabled.
6 = Enabled but Offline Indicates that the element may
be completing commands, and drop any new requests.
7 = In Test Indicates that the element is in a test state.
8 = Deferred Indicates that the element may be
completing commands, but will queue any new requests.
9 = Quiesce Indicates that the element is enabled but in
a restricted mode.
10 = Starting Indicates that the element is in the
process of going to an Enabled state. New requests are
queued.
11..32767 = DMTF Reserved
32768..65535 = Vendor Reserved
For example, shutting down (value = 4) and starting (value =
10) are transient states between enabled and disabled.
IPv4Address
The IPv4 address that this ProtocolEndpoint represents.
IPv6Address
The IPv6 address that this ProtocolEndpoint represents.
IPv6AddressType
Identifies the type of address found in the IPv6Address
property. The values of this property are interpreted
according to RFC4291, Section 2.4
Possible values are:
2 = Unspecified
3 = Loopback
4 = Multicast
5 = Link Local Unicast
6 = Global Unicast
7 = Embedded IPv4 Address
8 = Site Local Unicast
.. = DMTF Reserved
32768..65535 = Vendor Reserved
IPv6SubnetPrefixLength
Identifies the prefix length of the IPv6Address property that is
used to specify a subnet
IPVersionSupport
This property explicitly defines support for different versions
of the IP protocol, for this Endpoint. It is deprecated since the
ProtocolIFType also provides this functionality by describing
52 Dell Command | Monitor 10.3 classes and properties