Reference Guide

Table 8. DHCPProtocolEndpoint (continued)
Property Description
● 32768..65535 = Vendor specified
CreationClassName
Indicates the name of the class or the subclass used in the creation of an
instance. When used with the other key properties of this class, this property
allows all instances of this class and its subclasses to be uniquely identified.
ElementName
A user-friendly name for the object. This property allows each instance to define a
user-friendly name in addition to its key properties, identity data, and description
information.
NOTE: The Name property of ManagedSystemElement is also defined as a
user-friendly name. But, it is often subclassed to be a Key. It is not reasonable
that the same property can convey both identity and a user-friendly name,
without inconsistencies. Where Name exists and is not a Key (such as for
instances of LogicalDevice), the same information can be present in both the
Name and ElementName properties.
EnabledDefault
An enumerated value indicating an administrator's default or startup configuration
for the Enabled State of an element.
Possible values are:
● 2 = Enabled
● 3 = Disabled
● 5 = Not Applicable
● 6 = Enabled but Offline
● 7 = No Default
● 9 = Quiesce
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
EnabledState
An integer enumeration that indicates the enabled and disabled states of an
element. It can also indicate the transitions between these requested states. For
example, shutting down (value = 4) and starting (value = 10) are transient states
between enabled and disabled.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Enabled — Indicates that the element is or could be executing commands,
will process any queued commands, and queues new requests.
● 3 = Disabled — Indicates that the element will not execute commands and will
drop any new requests.
● 4 = Shutting Down — Indicates that the element is in the process of going to
a Disabled state.
● 5 = Not Applicable — Indicates the element does not support being enabled or
disabled.
● 6 = Enabled but Offline — Indicates that the element may be completing
commands, and will drop any new requests.
● 7 = In Test — Indicates that the element is in a test state.
● 8 = Deferred — Indicates that the element may be completing commands, but
will queue any new requests.
● 9 = Quiesce — Indicates that the element is enabled but in a restricted mode.
● 10 = Starting — Indicates that the element is in the process of going to an
Enabled state. New requests are queued.
● 11..32767 = DMTF Reserved
● 32768..65535 = Vendor Reserved
Dell Command | Monitor 10.3 classes and properties
39