Reference Guide

Table 96. MemoryError (continued)
Property Description
LogicalDevice), the same information can be present in both the Name and
ElementName properties.
ErrorInfo
An integer enumeration describing the type of error that occurred most recently. For
example, single (value = 6) or double bit errors (7) can be specified using this
property. The values, 12 – 14, are undefined in the CIM Schema since in DMI, they
mix the semantics of the type of error and whether it was correctable or not. The
latter is indicated in the property, CorrectableError.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = OK
● 3 = Bad Read
● 4 = Parity Error
● 5 = Single-Bit Error
● 6 = Double-Bit Error
● 7 = Multi-Bit Error
● 8 = Nibble Error
● 9 = Checksum Error
● 10 = CRC Error
● 32768 = DIMM Disabled via Spare Activation
StartingAddress
Specifies the address of the memory error. The type of error is described by the
ErrorInfo property. If the ErrorInfo property is equal to 3, OK, then this property has
no meaning.
SystemCreationClassName
The scoping System's CreationClassName.
SystemName
The scoping System's Name.
DCIM_IdentityContext
Table 97. IdentityContext
Property Description
ElementInContext
An Identity whose context is defined.
ElementProvidingContext
The ManagedElement that provides context or scope for the Identity.
DCIM_OrderedComponent
Table 98. OrderedComponent
Property Description
AssignedSequence
AssignedSequence is an unsigned integer n that indicates the relative order of
ManagedElement instances. When n is a positive integer, it indicates a place in the
sequence of members, with smaller integers indicating earlier positions in the
sequence. The special value 0 indicates don't care. If two or more members have
the same non-zero sequence number, then the ordering between those members is
irrelevant, but they must all be ordered at the appropriate place in the overall
sequence. A series of examples will make ordering of members clearer: If all members
have the same sequence number, regardless of whether it is 0 or non-zero, any
234 Dell Command | Monitor 10.3 classes and properties