Reference Guide

DCIM_PowerManagementService
Table 41. PowerManagementService
Property Description
CreationClassName
Indicates the name of the class or the subclass that is used in the creation of an
instance. When used with the other key properties of this class, this property allows
all instances of this class and its subclasses to be uniquely identified.
ElementName
A user-friendly name for the object. This property allows each instance to define a
user-friendly name in addition to its key properties, identity data, and description
information.
NOTE: The Name property of ManagedSystemElement is also defined as a user-
friendly name. But, it is often subclassed to be a Key. It is not reasonable that
the same property can convey both identity and a user-friendly name, without
inconsistencies. Where Name exists and is not a Key (such as for instances of
LogicalDevice), the same information can be present in both the Name and
ElementName properties.
EnabledDefault
An enumerated value indicating an administrator's default or startup configuration
for the Enabled State of an element.
Possible values are:
● 2 = Enabled
● 3 = Disabled
● 5 = Not Applicable
● 6 = Enabled but Offline
● 7 = No Default
● 9 = Quiesce
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
EnabledState
An integer enumeration that indicates the enabled and disabled states of an element.
It can also indicate the transitions between these requested states. For example,
shutting down (value = 4) and starting (value = 10) are transient states between
enabled and disabled.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Enabled — Indicates that the element is or could be executing commands,
processes any queued commands, and queues new requests.
● 3 = Disabled — Indicates that the element will not run commands and drops any
new requests.
● 4 = Shutting Down — Indicates that the element is in the process of going to a
Disabled state.
● 5 = Not Applicable — Indicates that the element does not support being enabled
or disabled.
● 6 = Enabled but Offline — Indicates that the element may be completing
commands, and drops any new requests.
● 7 = In Test — Indicates that the element is in a test state.
● 8 = Deferred — Indicates that the element may be completing commands, but
queues any new requests.
● 9 = Quiesce — Indicates that the element is enabled but in a restricted mode.
● 10 = Starting — Indicates that the element is in the process of going to an
Enabled state. New requests are queued.
● 11..32767 = DMTF Reserved
Dell Command | Monitor 10.3 classes and properties
155