Reference Guide

Table 26. Fan (continued)
Property Description
example, the element may not be operating at optimal performance or it may be
reporting recoverable errors.
● 15 = Minor failure—All functionality is available but some may be degraded.
● 20 = Major failure—The element is failing. It is possible that some or all of the
functionality of this component is degraded or not working.
● 25 = Critical failure—The element is non-functional and recovery may not be
possible.
● 30 = Non-recoverable error—The element has completely failed, and recovery is
not possible. All functionality provided by this element has been lost.
● .. = DMTF Reserved
OperationalStatus
Indicates the current statuses of the element. Various operational statuses are
defined. Many of the enumeration's values are self-explanatory. However, a few are
not and are described here in more detail.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = OK
● 3 = Degraded
● 4 = Stressed—Indicates that the element is functioning, but needs attention.
Examples of Stressed states are overload, overheated, and so on.
● 5 = Predictive Failure—Indicates that an element is functioning nominally but
predicting a failure in the near future.
● 6 = Error
● 7 = Non-Recoverable Error
● 8 = Starting
● 9 = Stopping
● 10 = Stopped - Implies a clean and orderly stop.
● 11 = In Service—Describes an element being configured, maintained, cleaned, or
otherwise administered.
● 12 = No Contact—Indicates that the monitoring system has knowledge of this
element, but has never been able to establish communications with it.
● 13 = Lost Communication—Indicates that the ManagedSystem Element is known
to exist and has been contacted successfully in the past, but is currently
unreachable.
● 14 = Aborted—Implies an abrupt stop where the state and configuration of the
element may need to be updated.
● 15 = Dormant—Indicates that the element is inactive or quiesced.
● 16 = Supporting Entity in Error—Indicates that this element may be OK but that
another element, on which it is dependent, is in error. An example is a network
service or endpoint that cannot function due to lower-layer networking problems.
● 17 = Completed—Indicates that the element has completed its operation. This
value should be combined with either OK, Error, or Degraded so that a client can
tell if the complete operation Completed with OK (passed), Completed with Error
(failed), or Completed with Degraded (the operation finished, but it did not
complete OK or did not report an error).
● 18 = Power Mode—Indicates that the element has additional power model
information contained in the Associated PowerManagementService association.
● .. = DMTF Reserved
● 0x8000.. = Vendor Reserved
PrimaryStatus
Provides a high level status value, intended to align with Red-Yellow-Green type
representation of status. It should be used in conjunction with DetailedStatus to
provide high level and detailed health status of the ManagedElement and its
subcomponents.
Possible values are:
Dell Command | Monitor 10.4 classes and properties 99