Reference Guide

Table 24. PCIDevice (continued)
Property Description
Description
Provides a textual description of the object.
DeviceID
An address or other identifying information used to uniquely
name the LogicalDevice.
DeviceNumber
The device number assigned to this PCI device for this bus.
ElementName
A user-friendly name for the object. This property allows each
instance to define a user-friendly name in addition to its key
properties, identity data, and description information.
NOTE: The Name property of ManagedSystemElement is
also defined as a user-friendly name. But, it is often
subclassed to be a Key. It is not reasonable that the same
property can convey both identity and a user-friendly
name, without inconsistencies. Where Name exists and is
not a Key (such as for instances of LogicalDevice), the
same information can be present in both the Name and
ElementName properties.
EnabledDefault
An enumerated value indicating an administrator's default or
startup configuration for the Enabled State of an element.
Possible values are:
● 2 = Enabled
● 3 = Disabled
● 5 = Not Applicable
● 6 = Enabled but Offline
● 7 = No Default
● 9 = Quiesce
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
EnabledState
A number enumeration that indicates the enabled and disabled
states of an element. It can also indicate the transitions
between these requested states. For example, shutting down
(value = 4) and restarting (value = 10) are temporary states
between enabled and disabled.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Enabled—Indicates that the element is or could be
executing commands, will process any queued commands,
and queues new requests.
● 3 = Disabled—Indicates that the element will not execute
commands and will drop any new requests.
● 4 = Shutting Down—Indicates that the element is in the
process of going to a Disabled state.
● 5 = Not Applicable—Indicates the element does not
support being enabled or disabled.
● 6 = Enabled but Offline—Indicates that the element may
be completing commands, and will drop any new requests.
● 7 = In Test—Indicates that the element is in a test state.
● 8 = Deferred—Indicates that the element may be
completing commands, but will queue any new requests.
92 Dell Command | Monitor 10.4 classes and properties