Reference Guide

Table 23. Memory (continued)
Property Description
Possible values are:
● 0 = Unknown
● 1 = Readable
● 2 = Writeable
● 3 = Read/Write Supported
● 4 = Write Once
BlockSize
Size in bytes of the blocks which form this StorageExtent. If
variable block size, then the maximum block size in bytes
should be specified. If the block size is unknown or if a block
concept is not valid (for example, for AggregateExtents,
Memory or LogicalDisks), enter a 1.
ConsumableBlocks
The maximum number of blocks, of size BlockSize, which are
available for consumption when layering StorageExtents using
the BasedOn association. This property only has meaning
when this StorageExtent is an Antecedent reference in a
BasedOn relationship. For example, a StorageExtent could be
composed of 120 blocks. However, the Extent itself may use
20 blocks for redundancy data. If another StorageExtent is
BasedOn this Extent, only 100 blocks would be available to it.
This information (100 blocks is available for consumption)
is indicated in the ConsumableBlocks property.
CreationClassName
Indicates the name of the class or the subclass used in the
creation of an instance. When used with the other key
properties of this class, this property allows all instances of
this class and its subclasses to be uniquely identified.
DeviceID
An address or other identifying information used to uniquely
name the LogicalDevice.
ElementName
A user-friendly name for the object. This property allows each
instance to define a user-friendly name in addition to its key
properties, identity data, and description information.
NOTE: The Name property of ManagedSystemElement is
also defined as a user-friendly name. But, it is often
subclassed to be a Key. It is not reasonable that the same
property can convey both identity and a user-friendly
name, without inconsistencies. Where Name exists and is
not a Key (such as for instances of LogicalDevice), the
same information can be present in both the Name and
ElementName properties.
EnabledDefault
An enumerated value indicating an administrator's default or
startup configuration for the Enabled State of an element.
Possible values are:
● 2 = Enabled
● 3 = Disabled
● 5 = Not Applicable
● 6 = Enabled but Offline
● 7 = No Default
● 9 = Quiesce
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
86 Dell Command | Monitor 10.4 classes and properties