Reference Guide

Table 19. RemoteServiceAccessPoint (continued)
Property Description
● 3 = Disabled
● 5 = Not Applicable
● 6 = Enabled but Offline
● 7 = No Default
● 9 = Quiesce
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
EnabledState
An integer enumeration that indicates the enabled and
disabled states of an element. It can also indicate the
transitions between these requested states.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Enabled—Indicates that the element is or could be
executing commands, will process any queued commands,
and queues new requests.
● 3 = Disabled—Indicates that the element will not execute
commands and will drop any new requests.
● 4 = Shutting Down—Indicates that the element is in the
process of going to a Disabled state.
● 5 = Not Applicable—Indicates the element does not
support being enabled or disabled.
● 6 = Enabled but Offline—Indicates that the element may
be completing commands, and will drop any new requests.
● 7 = In Test—Indicates that the element is in a test state.
● 8 = Deferred—Indicates that the element may be
completing commands, but will queue any new requests.
● 9 = Quiesce—Indicates that the element is enabled but in
a restricted mode.
● 10 = Starting—Indicates that the element is in the process
of going to an Enabled state. New requests are queued.
● 11..32767 = DMTF Reserved
● 32768..65535 = Vendor Reserved
For example, shutting down (value = 4) and starting (value =
10) are transient states between enabled and disabled.
InfoFormat
An enumerated integer that describes the format and
interpretation of the AccessInfo property.
Possible values are:
● 1 = Other
● 2 = Host Name
● 3 = IPv4 Address
● 4 = IPv6 Address
● 5 = IPX Address
● 6 = DECnet Address
● 7 = SNA Address
● 8 = Autonomous System Number
● 9 = MPLS Label
● 10 = IPv4 Subnet Address
● 11 = IPv6 Subnet Address
● 12 = IPv4 Address Range
● 13 = IPv6 Address Range
● 100 = Dial String
Dell Command | Monitor 10.4 classes and properties 69