Reference Guide

Table 10. FlatPanel (continued)
Property Description
ElementName
A user-friendly name for the object. This property allows each instance to define a
user-friendly name in addition to its key properties, identity data, and description
information.
NOTE: The Name property of ManagedSystemElement is also defined as a user-
friendly name. But, it is often subclassed to be a Key. It is not reasonable that
the same property can convey both identity and a user-friendly name, without
inconsistencies. Where Name exists and is not a Key (such as for instances of
LogicalDevice), the same information can be present in both the Name and
ElementName properties.
HorizontalResolution
The horizontal resolution in Pixels of the flat panel.
MaxQuiesceTime
The use of this property has been deprecated. When evaluating the use of Quiesce,
it was determined that this single property is not adequate for describing when a
device will automatically exit a quiescent state. In fact, the most likely scenario for a
device to exit a quiescent state was determined to be based on the number of
outstanding requests queued rather than on a maximum time. This decision will be
re-evaluated and repositioned later. Deprecated description: Maximum time, in
milliseconds, that a Device can run in a Quiesced state. The state is defined in its
Availability and Additional Availability properties, where Quiesced is conveyed by the
value 21. What occurs at the end of the time limit is device-specific. The Device can
unquiesce, can be offline, or can take other actions. A value of 0 indicates that a
Device can remain quiesced indefinitely.
ScanMode
The scan mode of a flat panel indicating either single (value = 2) or dual scan 3.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Single Scan
● 3 = Dual Scan
SystemCreationClassName
The creation class name of the scoping system.
SystemName
The system name of the scoping system.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
● 0 = Unknown
● 2 = Enabled
● 3 = Disabled
● 4 = Shut Down
● 5 = No Change—Indicates that no transition is in progress.
● 6 = Offline
● 7 = Test
●
8 = Defer
● 9 = Quiesce
● 10 = Reboot
● 11 = Reset
● 12 = Not Applicable—Indicates that the implementation does not support
representing ongoing transitions.
A value other than 5 or 12 identifies the state to which the element is in the process
of transitioning.
VerticalResolution
Vertical resolution in Pixels of a flat panel.
50 Dell Command | Monitor 10.4 classes and properties