Reference Guide

Table Of Contents
Table 150. BIOS settings supported in Dell Command | Monitor 10.4 (continued)
BIOS Settings Name Description Supported
Operating
System(s)
RS485
Serial Port 5
Configures the systems 5th serial port.
Possible values are:
DisabledDisables the 5th serial port.
AutoEnables the auto-configuration of the 5th serial
port.
Windows, Linux
Serial Port 6
Configures the 6th serial port of the system.
Possible values are:
DisabledDisables the 6th serial port.
AutoEnables the auto-configuration of the 6th serial
port.
Windows, Linux
SERR DMI Message
Enables or Disables SERR DMI Messages.
Possible values are:
Off
On
Windows, Linux
Service OS Clear
Deletes the service OS non-volatile region.
Possible values are:
EnabledDeletes the service OS non-volatile region
and changes the BIOS setting status to Disabled.
DisabledDoes not delete the service OS non-volatile
region.
Windows, Linux
Set CMOS To Default
Request or do not request a default of CMOS values on the
next boot.
Possible values are:
Disabled
Enabled
Windows
SFP
Enables or Disables Small Formfactor Pluggable (SFP)
device.
Possible values are:
DisabledDisables the SFP device.
EnabledEnables the SFP device.
Enabled With PXEEnables the SFP device with PXE
support.
NOTE: SFP device is listed as boot device only if this
BIOS setting is Enabled with PXE.
Windows, Linux
SFP Wake on LAN
Possible values:
SFPAllows the system to wake-up by special SFP
signals.
LAN or PXEAllows the system to wake-up either by
LAN, or by SFP signals.
SFP PXEAllows the system to wake-up by SFP
singnals, and immediately boot to PXE.
Windows, Linux
Side USB Ports
Enables or Disables all the side ports.
Windows, Linux
306 BIOS settings supported in Dell Command | Monitor 10.4