Reference Guide

Table Of Contents
BIOS settings supported in Dell Command |
Monitor 10.4
Following is the list of BIOS settings that are supported in Dell Command | Monitor.
Table 150. BIOS settings supported in Dell Command | Monitor 10.4
BIOS Settings Name Description Supported
Operating
System(s)
Absolute Sets the value to the Absolute interface and controls the
Absolute service.
Possible values:
EnabledIf Enabled, then the Absolute service is
activated or deactivated.
DisabledIf Disabled, then the Absolute service does
not run.
Permanently DisabledIf the Absolute interface is
permanently Disabled, then the Absolute feature can be
Enabled by using the factory reset feature.
Windows, Linux
Active State Power Management
Set the ASPM (Active State Power Management) level.
Possible values are:
AutoThere is handshaking between the device and
PCI Express hub to determine the best ASPM mode
supported by the device.
DisabledASPM power management is turned off
always.
L1 OnlyASPM power management is set to use L1.
Windows, Linux
Activity LED
Sets the Network Activity Light Emitting Diode (LED) to
any of the following:
Possible values are:
1 = EnabledACPIOSControlSets the Activity LED
controlled by an Advanced Configuration and Power
Interface (ACPI) operating system and driver.
2 = WirelessLANIndicatorSets the Activity LED as a
wireless Local Area Network (LAN) radio on/off
indicator.
3 = OffSets the Activity LED to off.
Windows, Linux
AGP Slot
Enables or Disables the on-board AGP slot.
Possible values are:
Disabled
Enabled
Windows
AC Power Recovery Mode
Sets AC Power Recovery Mode.
Possible values are:
Off
Last
Windows, Linux
6
BIOS settings supported in Dell Command | Monitor 10.4 253