Reference Guide

Table 132. ElementSettingData (continued)
Property Description
associated SettingData instance defines desired maximum setting values. The
operational maximum values should be modeled as a properties of the
CIM_ManagedElement instance. When IsMaximum = Is Not Maxiumum, this
property indicates that the affected property values specified in the associated
SettingData instance does not define desired maximum setting values. When
IsMaximum = Unknown, this property indicates that the affected property
values specified in the associated SettingData instance may correspond to
maximum desired setting values. When IsMaximum = Not Applicable, this
property indicates that the affected property values specified in the associated
SettingData instance is not interpreted with respect to whether each defines a
desired maximum.
Possible values are:
● 0 = Unknown
● 1 = Not Applicable
● 2 = Is Maximum
● 3 = Is Not Maximum
IsMinimum
This property affects the interpretation of all non-null, non-enumerated, non-binary,
numeric, non-key properties of the associated SettingData instance. All other
properties of the associated SettingData instance are not affected by this property.
NOTE: It is assumed that the semantics of each property of this set are
designed to be compared mathematically. When IsMinimum = Is Miniumum, this
property indicates that the affected property values specified in the associated
SettingData instance defines desired minimum setting values. The operational
minimum values should be modeled as a properties of the CIM_ManagedElement
instance. When IsMinimum = Is Not Miniumum, this property indicates that the
affected property values specified in the associated SettingData instance does
not define desired minimum setting values. When IsMinimum = Unknown, this
property indicates that the affected property values specified in the associated
SettingData instance may correspond to minimum desired setting values. When
IsMinimum = Not Applicable, this property indicates that the affected property
values specified in the associated SettingData instance is not interpreted with
respect to whether each defines a desired minimum.
Possible values are:
● 0 = Unknown
● 1 = Not Applicable
● 2 = Is Minimum
● 3 = Is Not Minimum
IsNext
An enumerated integer indicating whether or not the referenced setting is the next
setting to be applied. For example, the application could take place on a re-
initialization, reset, reconfiguration request. This could be a permanent setting, or a
setting used only one time, as indicated by the flag. If it is a permanent setting then
the setting is applied every time the managed element reinitializes, until this flag is
manually reset. However, if it is single use, then the flag is automatically cleared
after the settings are applied. Also note that if this flag is specified (i.e. set to value
other than Unknown), then this takes precedence over any SettingData that may
have been specified as Default. For example: If the managed element is a computer
system, and the value of this flag is Is Next, then the setting will be effective next
time the system resets. And, unless this flag is changed, it will persist for subsequent
system resets. However, if this flag is set to Is Next For Single Use, then this
setting will only be used once and the flag would be reset after that to Is Not Next.
So, in the above example, if the system reboots in a quick succession, the setting will
not be used at the second reboot.
Possible values are:
Dell Command | Monitor 10.4 classes and properties 245