Reference Guide

Table 81. PowerManagementCapabilities (continued)
Property Description
(:). When using this algorithm, the first colon to appear in InstanceID must appear
between <OrgID> and <LocalID> . <LocalID> is chosen by the business entity and
should not be reused to identify different underlying (real-world) elements. If the
above preferred algorithm is not used, the defining entity must assure that the
resulting InstanceID is not reused across any InstanceIDs produced by this or other
providers for the NameSpace of this instance. For DMTF-defined instances, the
preferred algorithm must be used with the <OrgID>set to CIM.
PowerChangeCapabilities
An enumeration indicating the specific power-related capabilities of a managed
element. Since this is an array, multiple values may be specified.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Power Saving Modes Entered Automatically—Indicates that a managed
element can change its power state based on usage or other criteria
● 3 = Power State Settable—Indicates that the RequestPowerStateChange
method is supported
● 4 = Power Cycling Supported—Indicates that the RequestPowerStateChange
method can be invoked with the PowerState input variable set to Power Cycle
(Off Soft)
● 5 = Timed Power On Supported—Indicates that the RequestPowerStateChange
method can be invoked with the PowerState input variable set to 'Power On' and
the Time parameter set to a specific date and time, or interval, for power on.
● 6 = Off Hard Power Cycling Supported
● 7 = HW Reset Supported
● 8 = Graceful Shutdown Supported—Indicates that the managed element can be
sent a hardware signal requesting an orderly shutdown prior to the requested
power state change.
PowerStatesSupported
An enumeration that indicates the power states supported by a managed element.
Because this is an array, multiple values can be specified. The current values in the
enumeration are:
● 2 = On—Corresponds to ACPI state G0 or S0 or D0.
● 3 = Sleep - Light—C orresponds to ACPI state G1, S1/S2, or D1.
● 4 = Sleep - Deep—Ccorresponds to ACPI state G1, S3, or D2.
● 5 = Power Cycle (Off - Soft)—Corresponds to ACPI state G2, S5, or D3, but
where the managed element is set to return to power state On at a pre-
determined time.
● 6 = Off—Hard, corresponding to ACPI state G3, S5, or D3.
● 7 = Hibernate (Off - Soft)—Corresponds to ACPI state S4, where the state of
the managed element is preserved and will be recovered upon powering on.
● 8 = Off—Soft, corresponding to ACPI state G2, S5, or D3.
● 9 = Power Cycle (Off-Hard)—Corresponds to the managed element reaching the
ACPI state G3 followed by ACPI state S0.
● 10 = Master Bus Reset, corresponds to the system reaching ACPI state S5
followed by ACPI state S0. This is used to represent system master bus reset.
● 11 = Diagnostic Interrupt (NMI)—Corresponds to the system reaching ACPI state
S5 followed by ACPI state S0. This is used to represent system non-maskable
interrupt.
● 12 = Off - Soft Graceful—Equivalent to Off Soft but preceded by a request to
the managed element to perform an orderlyshutdown.
● 13 = Off - Hard Graceful—Equivalent to Off Hard but preceded by a request to
the managed element to perform an orderly shutdown.
● 14 = Master Bus Rest Graceful—Equivalent to Master Bus Reset but preceded
by a request to the managed element to perform an orderly shutdown.
Dell Command | Monitor 10.4 classes and properties
219