Reference Guide

Table 38. TimeService (continued)
Property Description
If knowledge of the last RequestedState is not supported for the
EnabledLogicalElement, the property is NULL or has the value 12 Not Applicable.
SystemCreationClassName
The CreationClassName of the scoping System.
SystemName
The Name of the scoping System.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
● 0 = Unknown
● 2 = Enabled
● 3 = Disabled
● 4 = Shut Down
● 5 = No Change—Indicates that no transition is in progress.
● 6 = Offline
● 7 = Test
●
8 = Defer
● 9 = Quiesce
● 10 = Reboot
● 11 = Reset
● 12 = Not Applicable—Indicates the implementation does not support representing
ongoing transitions.
A value other than 5 or 12 identifies the state to which the element is in the process
of transitioning.
DCIM_AccountManagementService
Table 39. AccountManagementService
Property Description
CreationClassName
Indicates the name of the class or the subclass that is used in the creation of an
instance. When used with the other key properties of this class, this property allows
all instances of this class and its subclasses to be uniquely identified.
ElementName
A user-friendly name for the object. This property allows each instance to define a
user-friendly name in addition to its key properties, identity data, and description
information.
NOTE: The Name property of ManagedSystemElement is also defined as a user-
friendly name. But, it is often subclassed to be a Key. It is not reasonable that
the same property can convey both identity and a user-friendly name, without
inconsistencies. Where Name exists and is not a Key (such as for instances of
LogicalDevice), the same information can be present in both the Name and
ElementName properties.
EnabledDefault
An enumerated value indicating an administrator's default or startup configuration
for the Enabled State of an element.
Possible values are:
● 2 = Enabled
● 3 = Disabled
● 5 = Not Applicable
● 6 = Enabled but Offline
● 7 = No Default
150 Dell Command | Monitor 10.4 classes and properties