Reference Guide

Table 33. DeviceBay (continued)
Property Description
EnabledDefault
An enumerated value indicating an administrator's default or startup configuration
for the Enabled State of an element.
Possible values are:
● 2 = Enabled
● 3 = Disabled
● 5 = Not Applicable
● 6 = Enabled but Offline
● 7 = No Default
● 9 = Quiesce
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
EnabledState
An integer enumeration that indicates the enabled and disabled states of an element.
It can also indicate the transitions between these requested states.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Enabled—Indicates that the element is or could be executing commands, will
process any queued commands, and queues new requests.
● 3 = Disabled—Indicates that the element will not execute commands and will
drop any new requests.
● 4 = Shutting Down—Indicates that the element is in the process of going to a
Disabled state.
● 5 = Not Applicable—Indicates the element does not support being enabled or
disabled.
● 6 = Enabled but Offline—Indicates that the element may be completing
commands, and will drop any new requests.
● 7 = In Test—Indicates that the element is in a test state.
● 8 = Deferred—Indicates that the element may be completing commands, but will
queue any new requests.
● 9 = Quiesce—Indicates that the element is enabled but in a restricted mode.
● 10 = Starting—Indicates that the element is in the process of going to an
Enabled state. New requests are queued.
● 11..32767 = DMTF Reserved
● 32768..65535 = Vendor Reserved
IdentifyingDescriptions
An array of free-form strings providing explanations and details behind the entries in
the OtherIdentifyingInfo array. Note that each entry of this array is related to the
entry in OtherIdentifyingInfo that is located at the same index.
LogicalModuleType
Identifies the type of LogicalModule this instance represents.
Possible values are:
● 0 = Unknown—Indicates that the LogicalModuleType is unknown.
● 1 = Other—Indicates that the value is not one of the enumerated values.
OtherLogicalModuleTypeDescription should contain additional information.
● 2 = Device Tray—Indicates that the device is a device or media tray, for example
in a modular system.
● 3 = Line Card—Indicates that the module is a line card in a switch.
● 4 = Blade—Indicates the module is a blade inserted into a switch.
●
5..32767 = DMTF Reserved
● 32768..65535 = Vendor Reserved
136 Dell Command | Monitor 10.4 classes and properties